1
Copyright © 2021 Pearson Education, Inc.
ao ao ao ao ao
VERIFIEDBRAINBOOSTER
,Automotive Steering, Suspension, & Alignment, 8e (Halderman) ao ao ao ao ao ao ao
Appendix 1 ao
1) A customer complains that the steering lacks power assist all the time. Technician A says that
ao ao ao ao ao ao ao ao ao ao ao ao ao ao ao ao
the power steering pump drive belt could be slipping or loose. Technician B says that worn outer t
ao ao ao ao ao ao ao ao ao ao ao ao ao ao ao ao ao
ie rod ends could be the cause. Which technician is correct?
ao ao ao ao ao ao ao ao ao ao
A) Technician A only ao ao
B) Technician B only ao ao
C) Both Technicians A and B ao ao ao ao
D) Neither Technician A nor B ao ao ao ao ao
Answer: A a o
2) A front-wheel-
ao
drive vehicle pulls toward the right during hard acceleration. The most likely cause is .
ao ao ao ao ao ao ao ao ao ao ao ao ao ao
A) worn or defective tires ao ao ao
B) leaking or defective shock absorbers ao ao ao ao
C) normal torque steer ao ao
D) a defective power steering rack-and-
ao ao ao ao
pinion steering assembly Answer: C
ao ao ao a o
3) When replacing a rubber-bonded socket (RBS) tie rod end, the technician should be sure to
ao ao ao ao ao ao ao ao ao ao ao ao ao ao
.
A) remove the original using a special tool ao ao ao ao ao ao
B) install and tighten the replacement with the front wheels in the straight-ahead position
ao ao ao ao ao ao ao ao ao ao ao ao
C) grease the joint before installing on the vehicle
ao ao ao ao ao ao ao
D) install the replacement using a special clamp vise
ao ao ao ao ao ao ao ao
Answer: B a o
4) Whenever installing a tire on a rim, do not exceed ao ao ao ao ao ao ao ao ao ao .
A) 25 PSI ao
B) 30 PSI ao
C) 35 PSI ao
D) 40 PSI ao
Answer: D a o
5) Two technicians are discussing mounting a tire on a wheel. Technician A says that for best ba
ao ao ao ao ao ao ao ao ao ao ao ao ao ao ao ao
lance, the tire should be match mounted. Technician B says that silicone spray should be used to l
ao ao ao ao ao ao ao ao ao ao ao ao ao ao ao ao ao
ubricate the tire bend. Which technician is correct?
ao ao ao ao ao ao ao
A) Technician A only ao ao
B) Technician B only ao ao
C) Both Technicians A and B ao ao ao ao
D) Neither Technician A nor B ao ao ao ao ao
Answer: A a o
2
Copyright © 2021 Pearson Education, Inc.
ao ao ao ao ao
VERIFIEDBRAINBOOSTER
,6) Technician A says that radial tires should only be rotated front to rear, never side to side.
ao ao ao ao ao ao ao ao ao ao ao ao ao ao ao ao ao
Technician B says that vehicle manufacturers usually recommend that radial tires should be r
ao ao ao ao ao ao ao ao ao ao ao ao ao
otated using the modified X method. Which technician is correct?
ao ao ao ao ao ao ao ao ao
A) Technician A only ao ao
B) Technician B only ao ao
C) Both Technicians A and B ao ao ao ao
D) Neither Technician A nor B ao ao ao ao ao
Answer: B a o
7) For a tire that has excessive radial runout, Technician A says that it should be broken down on
ao ao ao ao ao ao ao ao ao ao ao ao ao ao ao ao ao ao
a tire-
ao
changing machine and then rotated 180 degrees on the wheel and retested. Technician B says tha
ao ao ao ao ao ao ao ao ao ao ao ao ao ao ao
t the tire should be replaced. Which technician is correct?
ao ao ao ao ao ao ao ao ao
A) Technician A only ao ao
B) Technician B only ao ao
C) Both Technicians A and B ao ao ao ao
D) Neither Technician A nor B ao ao ao ao ao
Answer: A a o
8) Technician A says that overloading a vehicle can cause damage to the wheel bearings. Techni
ao ao ao ao ao ao ao ao ao ao ao ao ao ao
cian B says that tapered roller bearings used on a nondrive wheel should be adjusted hand tight on
ao ao ao ao ao ao ao ao ao ao ao ao ao ao ao ao ao
ly after seating. Which technician is correct?
ao ao ao ao ao ao
A) Technician A only ao ao
B) Technician B only ao ao
C) Both Technicians A and B ao ao ao ao
D) Neither Technician A nor B ao ao ao ao ao
Answer: C a o
9) Defective wheel bearings usually sound like ao ao ao ao ao ao .
A) a growl ao
B) a rumble ao
C) snow tires ao
D) All of the above ao ao ao ao
Answer: D a o
10) Defective outer CV joints usually make a clicking noise ao ao ao ao ao ao ao ao ao
A) only when backing ao ao
B) while turning and moving ao ao ao
C) while turning only ao ao
D) during braking ao a
Answer: B
o a o
11) The proper lubricant usually specified for use in a differential is
ao ao ao ao ao ao ao ao ao ao ao .
A) SAE 15-40 engine oil ao ao ao
B) SAE 80W-90 GL-5 ao ao
C) STF
D) SAE 80W-140 GL-1 ao ao
3
Copyright © 2021 Pearson Education, Inc.
ao ao ao ao ao
VERIFIEDBRAINBOOSTER
, Answer: B
a o
4
Copyright © 2021 Pearson Education, Inc.
ao ao ao ao ao
VERIFIEDBRAINBOOSTER
Copyright © 2021 Pearson Education, Inc.
ao ao ao ao ao
VERIFIEDBRAINBOOSTER
,Automotive Steering, Suspension, & Alignment, 8e (Halderman) ao ao ao ao ao ao ao
Appendix 1 ao
1) A customer complains that the steering lacks power assist all the time. Technician A says that
ao ao ao ao ao ao ao ao ao ao ao ao ao ao ao ao
the power steering pump drive belt could be slipping or loose. Technician B says that worn outer t
ao ao ao ao ao ao ao ao ao ao ao ao ao ao ao ao ao
ie rod ends could be the cause. Which technician is correct?
ao ao ao ao ao ao ao ao ao ao
A) Technician A only ao ao
B) Technician B only ao ao
C) Both Technicians A and B ao ao ao ao
D) Neither Technician A nor B ao ao ao ao ao
Answer: A a o
2) A front-wheel-
ao
drive vehicle pulls toward the right during hard acceleration. The most likely cause is .
ao ao ao ao ao ao ao ao ao ao ao ao ao ao
A) worn or defective tires ao ao ao
B) leaking or defective shock absorbers ao ao ao ao
C) normal torque steer ao ao
D) a defective power steering rack-and-
ao ao ao ao
pinion steering assembly Answer: C
ao ao ao a o
3) When replacing a rubber-bonded socket (RBS) tie rod end, the technician should be sure to
ao ao ao ao ao ao ao ao ao ao ao ao ao ao
.
A) remove the original using a special tool ao ao ao ao ao ao
B) install and tighten the replacement with the front wheels in the straight-ahead position
ao ao ao ao ao ao ao ao ao ao ao ao
C) grease the joint before installing on the vehicle
ao ao ao ao ao ao ao
D) install the replacement using a special clamp vise
ao ao ao ao ao ao ao ao
Answer: B a o
4) Whenever installing a tire on a rim, do not exceed ao ao ao ao ao ao ao ao ao ao .
A) 25 PSI ao
B) 30 PSI ao
C) 35 PSI ao
D) 40 PSI ao
Answer: D a o
5) Two technicians are discussing mounting a tire on a wheel. Technician A says that for best ba
ao ao ao ao ao ao ao ao ao ao ao ao ao ao ao ao
lance, the tire should be match mounted. Technician B says that silicone spray should be used to l
ao ao ao ao ao ao ao ao ao ao ao ao ao ao ao ao ao
ubricate the tire bend. Which technician is correct?
ao ao ao ao ao ao ao
A) Technician A only ao ao
B) Technician B only ao ao
C) Both Technicians A and B ao ao ao ao
D) Neither Technician A nor B ao ao ao ao ao
Answer: A a o
2
Copyright © 2021 Pearson Education, Inc.
ao ao ao ao ao
VERIFIEDBRAINBOOSTER
,6) Technician A says that radial tires should only be rotated front to rear, never side to side.
ao ao ao ao ao ao ao ao ao ao ao ao ao ao ao ao ao
Technician B says that vehicle manufacturers usually recommend that radial tires should be r
ao ao ao ao ao ao ao ao ao ao ao ao ao
otated using the modified X method. Which technician is correct?
ao ao ao ao ao ao ao ao ao
A) Technician A only ao ao
B) Technician B only ao ao
C) Both Technicians A and B ao ao ao ao
D) Neither Technician A nor B ao ao ao ao ao
Answer: B a o
7) For a tire that has excessive radial runout, Technician A says that it should be broken down on
ao ao ao ao ao ao ao ao ao ao ao ao ao ao ao ao ao ao
a tire-
ao
changing machine and then rotated 180 degrees on the wheel and retested. Technician B says tha
ao ao ao ao ao ao ao ao ao ao ao ao ao ao ao
t the tire should be replaced. Which technician is correct?
ao ao ao ao ao ao ao ao ao
A) Technician A only ao ao
B) Technician B only ao ao
C) Both Technicians A and B ao ao ao ao
D) Neither Technician A nor B ao ao ao ao ao
Answer: A a o
8) Technician A says that overloading a vehicle can cause damage to the wheel bearings. Techni
ao ao ao ao ao ao ao ao ao ao ao ao ao ao
cian B says that tapered roller bearings used on a nondrive wheel should be adjusted hand tight on
ao ao ao ao ao ao ao ao ao ao ao ao ao ao ao ao ao
ly after seating. Which technician is correct?
ao ao ao ao ao ao
A) Technician A only ao ao
B) Technician B only ao ao
C) Both Technicians A and B ao ao ao ao
D) Neither Technician A nor B ao ao ao ao ao
Answer: C a o
9) Defective wheel bearings usually sound like ao ao ao ao ao ao .
A) a growl ao
B) a rumble ao
C) snow tires ao
D) All of the above ao ao ao ao
Answer: D a o
10) Defective outer CV joints usually make a clicking noise ao ao ao ao ao ao ao ao ao
A) only when backing ao ao
B) while turning and moving ao ao ao
C) while turning only ao ao
D) during braking ao a
Answer: B
o a o
11) The proper lubricant usually specified for use in a differential is
ao ao ao ao ao ao ao ao ao ao ao .
A) SAE 15-40 engine oil ao ao ao
B) SAE 80W-90 GL-5 ao ao
C) STF
D) SAE 80W-140 GL-1 ao ao
3
Copyright © 2021 Pearson Education, Inc.
ao ao ao ao ao
VERIFIEDBRAINBOOSTER
, Answer: B
a o
4
Copyright © 2021 Pearson Education, Inc.
ao ao ao ao ao
VERIFIEDBRAINBOOSTER