NIMS Test II Exam ACTUAL QUESTIONS AND CORRECT ANSWERS

NIMS Test II Exam ACTUAL QUESTIONS AND
CORRECT ANSWERS
Unit of measure for lathe feed rate - CORRECT ANSWER IPR



To convert inches to millimeters, a machinist would use a constant of _________. -
CORRECT ANSWER 25.4



The feed rate for converting a hole on a drill press should be __________ that of drilling. -
CORRECT ANSWER 2 times



The feed rate for reaming a hole on a drill press should be __________ that of drilling. -
CORRECT ANSWER 1/8th



The most accurate method of measuring an angle is a : - CORRECT
ANSWER combination set



Which type of head for a combination set is the best choice for finding the center of a shaft? -
CORRECT ANSWER Center



A solid square has two sides that form an angle of ___________ degrees that checks
________________. - CORRECT ANSWER 90, perpendicularity



The resolution of a micrometer with a vernier scale is ___________ inches, - CORRECT
ANSWER 0.0001



The micrometer spindle has _________ threads er inch with a lead (amount of travel in one
revolution) of __________ inches. - CORRECT ANSWER 40, 0.025 inches



The most common type of tap found in the toolroom for creating threads for machine screws
is a __________ tap. - CORRECT ANSWER Plug