Smog Inspector BAR EXAM {Latest Update
} Practice Questions and
Verified Answers {Grade A} 100 % Correct
A Customer whose vehicle has failed the Smog Check inspection has been approved
for a repair cost waiver. How long is the duration of the repair cost waiver? - correct
answer Two years or 2 years
Technician A says that all vehicles with fuel evaporation from 1976 to 1995 are subject
to the LPFET functional test. Technician B says that only vehicles older than 1996
receiving a TSI test are subject to the functional EGR test. Who's correct? - correct
answer Both Technicians
The OBD II functional test evaluates and reports the status of all the following,
except? - correct answer Mode 6 Pending Codes
While conducting a functional test on an EGR valve, the technician increases RPM and
can see the valve Pinole move up. Based on that information, how would the
technician enter this condition into the emission inspection system (EIS)?
Pass
N/A
Defective
None of the above - correct answer NONE OF THE ABOVE
, Smog Inspector BAR EXAM {Latest Update
} Practice Questions and
Verified Answers {Grade A} 100 % Correct
Two technicians are discussing the procedures for performing the ignition timing
functional test. Technician A states that if no manufacturer engine speed tolerance is
given, the idle speed should be within 100 RPM of manufacturers specified idle speed.
Technician B states that if the procedures for timing check are nit found in the under
hood label the inspector must refer to the emission control application guide or the
manufacturer service Manual. Who's correct? - correct answer Both technicians
A smog technician is conducting an ASM smog test on a vehicle with a standard
transmission (stick). The engine size is 3.6L. What gear should the technician first try
to conduct the test and what RPM should he keep the engine within while conducting
the test? - correct answer 2nd gear with the RPM between 1250 and 2500
How often must you calibrate the BAR-97 EIS? - correct answer Every 72 hours or
when prompted NOT AND PROMPTED OR
The emission inspection system (EIS) shows a dilution error on the screen. What is the
EIS seeing at this time? - correct answer High O2
The TAC (Thermostatic Air Control) helps heath the incoming air to the induction
system. This control is accomplished by a vacuum operated blend door in the air
cleaner snorkel. When the nine is not running (0° manifold vacuum), in what position
is the blend door? - correct answer The "Hot air mode"
} Practice Questions and
Verified Answers {Grade A} 100 % Correct
A Customer whose vehicle has failed the Smog Check inspection has been approved
for a repair cost waiver. How long is the duration of the repair cost waiver? - correct
answer Two years or 2 years
Technician A says that all vehicles with fuel evaporation from 1976 to 1995 are subject
to the LPFET functional test. Technician B says that only vehicles older than 1996
receiving a TSI test are subject to the functional EGR test. Who's correct? - correct
answer Both Technicians
The OBD II functional test evaluates and reports the status of all the following,
except? - correct answer Mode 6 Pending Codes
While conducting a functional test on an EGR valve, the technician increases RPM and
can see the valve Pinole move up. Based on that information, how would the
technician enter this condition into the emission inspection system (EIS)?
Pass
N/A
Defective
None of the above - correct answer NONE OF THE ABOVE
, Smog Inspector BAR EXAM {Latest Update
} Practice Questions and
Verified Answers {Grade A} 100 % Correct
Two technicians are discussing the procedures for performing the ignition timing
functional test. Technician A states that if no manufacturer engine speed tolerance is
given, the idle speed should be within 100 RPM of manufacturers specified idle speed.
Technician B states that if the procedures for timing check are nit found in the under
hood label the inspector must refer to the emission control application guide or the
manufacturer service Manual. Who's correct? - correct answer Both technicians
A smog technician is conducting an ASM smog test on a vehicle with a standard
transmission (stick). The engine size is 3.6L. What gear should the technician first try
to conduct the test and what RPM should he keep the engine within while conducting
the test? - correct answer 2nd gear with the RPM between 1250 and 2500
How often must you calibrate the BAR-97 EIS? - correct answer Every 72 hours or
when prompted NOT AND PROMPTED OR
The emission inspection system (EIS) shows a dilution error on the screen. What is the
EIS seeing at this time? - correct answer High O2
The TAC (Thermostatic Air Control) helps heath the incoming air to the induction
system. This control is accomplished by a vacuum operated blend door in the air
cleaner snorkel. When the nine is not running (0° manifold vacuum), in what position
is the blend door? - correct answer The "Hot air mode"
