Sea School Final Exam Newest 2025
Complete 150 Correct Answers (Verified
Answers) |Already Graded A+
1) Chafing gear should always be placed at friction points to reduce wear on the
lines, the vessels and their equipment. If commercially produced chafing gear is
not available, any available_____ can be used as a temporary measure.
A) Hose
B) Leather
C) Cloth material
2) To get the vessels in step, _______ the towline if possible
Lenghten
3) Inspect towlines on a regular basis to detect damage from __________.
A) Cuts
B) Chafing
C) Fusing (caused by overheating or over-stretching)
4) A heaving line is made of light, flexible line with what at the thrown end?
Monkey's fist
5) Entrances from one compartment to another are called:
Doors
,6) The moment you attach a line to another vessel, you become __________.
responsible for the boat and all persons onboard
7) Some areas that may be marked by Yellow aids are:
A) Spoil areas
B) Pipeline
C) Traffic Separation Schemes
8) Shock-load could damage
A) Vessel fittings
B) Part the towline
C) Endanger personnel
9) Keep the legs of the bridle long enough so the angle of the legs is less than
____ degrees.
30 degrees
10) Dynamic forces occur once the towed vessel is ______
Moving
1) A gasoline fuel tank vent on a small passenger vessel should terminate
_________.
On the hull exterior as high above the waterline as practicable and remote from
any hull opening
2) What equipment must be on a life float? (small passenger vessel regulations)
Two paddles, a light, painter, lifeline and pendants
, 3) What is the minimum height of rails on passenger decks of ferryboats,
excursion vessels, and vessels of a similar type? (small passenger vessel
regulations)
39.5 inches
4) As appropriate for the voyage, all vessels must carry adequate and up-to-date
_____________. (small passenger vessel regulations)
A) charts
B) Coast Pilots
C) Light Lists
5) Painters on life floats shall be not less than ___________. (small passenger
vessel regulations)
100 feet in length
6) Escape hatches and other hatches in weather decks on passenger vessels
operating beyond protected waters __________
Must be watertight
7) Where must the draft or loading marks be placed on a small passenger
vessel?
A) On each side of the stem
B) Near the stern post or rudder post
C) At each end of the vessel
8) A Certificate of Inspection issued to a small passenger vessel describes
A) The minimum fire extinguishing equipment, lifejackets, survival and rescue craft
B) the name of the managing operator
Complete 150 Correct Answers (Verified
Answers) |Already Graded A+
1) Chafing gear should always be placed at friction points to reduce wear on the
lines, the vessels and their equipment. If commercially produced chafing gear is
not available, any available_____ can be used as a temporary measure.
A) Hose
B) Leather
C) Cloth material
2) To get the vessels in step, _______ the towline if possible
Lenghten
3) Inspect towlines on a regular basis to detect damage from __________.
A) Cuts
B) Chafing
C) Fusing (caused by overheating or over-stretching)
4) A heaving line is made of light, flexible line with what at the thrown end?
Monkey's fist
5) Entrances from one compartment to another are called:
Doors
,6) The moment you attach a line to another vessel, you become __________.
responsible for the boat and all persons onboard
7) Some areas that may be marked by Yellow aids are:
A) Spoil areas
B) Pipeline
C) Traffic Separation Schemes
8) Shock-load could damage
A) Vessel fittings
B) Part the towline
C) Endanger personnel
9) Keep the legs of the bridle long enough so the angle of the legs is less than
____ degrees.
30 degrees
10) Dynamic forces occur once the towed vessel is ______
Moving
1) A gasoline fuel tank vent on a small passenger vessel should terminate
_________.
On the hull exterior as high above the waterline as practicable and remote from
any hull opening
2) What equipment must be on a life float? (small passenger vessel regulations)
Two paddles, a light, painter, lifeline and pendants
, 3) What is the minimum height of rails on passenger decks of ferryboats,
excursion vessels, and vessels of a similar type? (small passenger vessel
regulations)
39.5 inches
4) As appropriate for the voyage, all vessels must carry adequate and up-to-date
_____________. (small passenger vessel regulations)
A) charts
B) Coast Pilots
C) Light Lists
5) Painters on life floats shall be not less than ___________. (small passenger
vessel regulations)
100 feet in length
6) Escape hatches and other hatches in weather decks on passenger vessels
operating beyond protected waters __________
Must be watertight
7) Where must the draft or loading marks be placed on a small passenger
vessel?
A) On each side of the stem
B) Near the stern post or rudder post
C) At each end of the vessel
8) A Certificate of Inspection issued to a small passenger vessel describes
A) The minimum fire extinguishing equipment, lifejackets, survival and rescue craft
B) the name of the managing operator
