OSHA 30 Module 17 Fall Protection Questions and Answers | Latest Version | 2024/2025 | Correct & Verified

OSHA 30 Module 17 Fall Protection Questions and Answers | Latest Version | 2024/2025 | Correct & Verified What is the recommended action for workers who will be working on scaffolding more than 10 feet high? Workers should use fall protection like a harness, lanyard, and anchor, or have guardrails in place to protect against falls How can workers reduce the risk of falls when working on fragile surfaces like roofs? Use proper fall protection equipment, avoid walking on fragile surfaces, and ensure that safe access points are available What type of fall protection is required when working in a hole or trench? Workers must use fall protection such as guardrails, toe boards, or a personal fall arrest system to prevent falls into the excavation How can workers avoid fall hazards when performing aerial lift work? Ensure the lift is properly stabilized, and use a personal fall arrest system attached to the basket or platform 2 Why is it important for employers to conduct a fall hazard assessment on construction sites? A hazard assessment helps identify areas where fall protection is needed and ensures that appropriate safety measures are in place What should workers do if they are working on a scaffold with an incomplete guardrail system? Stop work and report the issue to the supervisor until the proper fall protection system is installed Why is fall protection especially critical when working near holes, skylights, or other openings? These areas present significant fall risks, and fall protection systems prevent workers from falling through these openings What is the purpose of a safety net system in fall protection? A safety net system catches workers in case of a fall, reducing the severity of injuries What is the maximum allowable free-fall distance for workers using a personal fall arrest system? 3 The free-fall distance should not exceed six feet to minimize the risk of injury or impact with a lower level What is the main purpose of fall protection systems on construction sites? To prevent workers from falling from heights and minimize the risk of injury or death What should workers do if they notice a fall protection system is damaged or defective? Immediately report the issue to the supervisor and do not use the system until it is repaired or replaced Why is it important to inspect personal fall arrest systems before use? To ensure that all components are functioning properly and to prevent accidents caused by faulty equipment How should a worker be positioned when using a fall protection harness? The harness should fit snugly over the body with the D-ring positioned at the center of the back and not over the spine