ASQ CQT Exam Practice Questions and Answers 100% Pass

ASQ CQT Exam Practice Questions and Answers 100% Pass One advantage of 100% inspection over sampling inspection is that 100% inspection (A) provides more information about quality levels (B) gives zero defects to the customer (C) reduces the personal bias of the inspector (D) requires less machine-operator training - ANSWER-A provides more information about quality levels When the term "R & R" is applied to digital calipers, it refers to (A) removal and replacement (B) relativity and reproducibility (C) repeatability and reliability (D) repeatability and reproducibility - ANSWER-D repeatability and reproducibility The proper method of placing parts on a surface plate and then removing them is (A) rotate on and slide off Copyright © KAYLIN 2024/2025 ACADEMIC YEAR. ALL RIGHTS RESERVED Copyright ©Stuvia International BV Page 2/16 (B) rotate on and lift off (C) set on and slide off (D) set on and lift off - ANSWER-A rotate on and slide off Who is responsible for determining whether a follow-up response is sufficient to close out an internal audit? (A) Executive management (B) The quality manager (C) The audit team leader (D) The internal auditee - ANSWER-C The audit team leader Which of the following methods is used to develop an exhaustive list of ideas about a subject? (A) Goal-setting (B) Brainstorming (C) Benchmarking (D) Problem-solving - ANSWER-B Brainstorming A document that asserts that a product conforms to specification is known as a certificate of (A) qualification (B) validation (C) calibration Copyright © KAYLIN 2024/2025 ACADEMIC YEAR. ALL RIGHTS RESERVED Copyright ©Stuvia International BV Page 3/16 (D) compliance - ANSWER-D compliance Confidence limits are generated in order to define the (A) limits of random variation around a control value (B) limits that contain all future observations (C) interval within which a population parameter lies (D) amount of variation that the process exhibits - ANSWER-C interval within which a population parameter lies The purpose of a calibration schedule is to (A) detect deterioration of accuracy (B) meet ISO audit requirements (C) test inspector performance (D) increase product acceptance - ANSWER-A detect deterioration of accuracy What is the percent yield for a normally distributed process in which the item length specification is 5.750 ± 0.004, X is 5.752, and the standard deviation is 0.002 ? (A) 15.73% (B) 19.15% (C) 47.72% Copyright © KAYLIN 2024/2025 ACADEMIC YEAR. ALL RIGHTS RESERVED Copyright ©Stuvia International BV Page 4/16 (D) 83.99% - ANSWER-D 83.99% In preparation for construction of a cause and effect diagram, it is important to (A) plot separate charts for each source (B) focus only on what makes things go wrong (C) record everything people suggest (D) validate possible root causes - ANSWER-C record everything people suggest A quality technician uses a c chart to monitor the number of defects in a square foot of material. After the initial startup period, the mean number of defects is calculated at 13.5.