CYB 210 - Week 2 - 2-1 Quiz
Advantage: Optimal route exists between any two sites
Disadvantage: Expensive to scale because the addition of one new site requires a new
WAN link between the new site and every other existing site
- Bus Topology
- Ring Topology
- Star Topology
- Hub-and-Spoke WAN Topology
- Full-Mesh WAN Topology - ✔️✔️Full-Mesh WAN Topology
What is the proper subnet mask for an IP address of 192.168.1.1/24?
- 255.255.255.255
- 255.128.128.128
- 255.0.0.0
- 255.255.255.0 - ✔️✔️255.255.255.0
If a network is unknown, what is the name of the special address used to communicate
with it?
- Routing Table
- Default IP address
- Default gateway
- Switch address - ✔️✔️Default gateway
When configuring a floating static route, you must first do what?
- Upgrade the firmware
- Set the default IP address (not this one)
- Determine the alternate path
- Access the domain controller - ✔️✔️
What is the name of a Layer 2 connection that supports transporting multiple VLANs on
the same link between devices?
- Access port
- EtherChannel port
- Trunk port
- Multimode port - ✔️✔️Trunk port
What command is used to test communications with another machine on the network?
, - Ping
- No shutdown
- Exit
- Route - ✔️✔️Ping
Which is a network category based on close proximity of network components?
- Personal area network (PAN)
- Metropolitan area network (MAN)
- World area network (WAN)
- Local area network (LAN) - ✔️✔️Local area network (LAN)
Which of the following is not a layer of the Open Systems Interconnect (OSI) reference
model?Local Area Network (LAN)
- Communication access layer
- Physical layer
- Presentation layer
- Data link layer - ✔️✔️Communication access layer
Identify devices A and B in the following graphic.
Client, File Server, Client == A == B == Box == Client, Client.
- Device A is a router, and device B is a switch.
- Device A is a hub, and device B is a switch.
- Device A is a switch, and device B is a hub.
- Device A is a switch, and device B is a router. - ✔️✔️Device A is a switch, and device
B is a router.
Match the network topology with the correct advantage/disadvantage pair:
Advantage: A cable break only impacts the device connected via the broken cable and
not the entire topology
Disadvantage: Installation can take longer, and costs increase because more cable runs
must be installed
- Bus Topology
- Ring Topology
- Star Topology
- Hub-and-Spoke WAN Topology
- Full-Mesh WAN Topology - ✔️✔️Star Topology
Match the network topology with the correct advantage/disadvantage pair:
Advantage: Less cable is needed to install; therefore, usually less expensive
Advantage: Optimal route exists between any two sites
Disadvantage: Expensive to scale because the addition of one new site requires a new
WAN link between the new site and every other existing site
- Bus Topology
- Ring Topology
- Star Topology
- Hub-and-Spoke WAN Topology
- Full-Mesh WAN Topology - ✔️✔️Full-Mesh WAN Topology
What is the proper subnet mask for an IP address of 192.168.1.1/24?
- 255.255.255.255
- 255.128.128.128
- 255.0.0.0
- 255.255.255.0 - ✔️✔️255.255.255.0
If a network is unknown, what is the name of the special address used to communicate
with it?
- Routing Table
- Default IP address
- Default gateway
- Switch address - ✔️✔️Default gateway
When configuring a floating static route, you must first do what?
- Upgrade the firmware
- Set the default IP address (not this one)
- Determine the alternate path
- Access the domain controller - ✔️✔️
What is the name of a Layer 2 connection that supports transporting multiple VLANs on
the same link between devices?
- Access port
- EtherChannel port
- Trunk port
- Multimode port - ✔️✔️Trunk port
What command is used to test communications with another machine on the network?
, - Ping
- No shutdown
- Exit
- Route - ✔️✔️Ping
Which is a network category based on close proximity of network components?
- Personal area network (PAN)
- Metropolitan area network (MAN)
- World area network (WAN)
- Local area network (LAN) - ✔️✔️Local area network (LAN)
Which of the following is not a layer of the Open Systems Interconnect (OSI) reference
model?Local Area Network (LAN)
- Communication access layer
- Physical layer
- Presentation layer
- Data link layer - ✔️✔️Communication access layer
Identify devices A and B in the following graphic.
Client, File Server, Client == A == B == Box == Client, Client.
- Device A is a router, and device B is a switch.
- Device A is a hub, and device B is a switch.
- Device A is a switch, and device B is a hub.
- Device A is a switch, and device B is a router. - ✔️✔️Device A is a switch, and device
B is a router.
Match the network topology with the correct advantage/disadvantage pair:
Advantage: A cable break only impacts the device connected via the broken cable and
not the entire topology
Disadvantage: Installation can take longer, and costs increase because more cable runs
must be installed
- Bus Topology
- Ring Topology
- Star Topology
- Hub-and-Spoke WAN Topology
- Full-Mesh WAN Topology - ✔️✔️Star Topology
Match the network topology with the correct advantage/disadvantage pair:
Advantage: Less cable is needed to install; therefore, usually less expensive
