JLTV USMC Questions and Answers Already Passed

JLTV USMC Questions and Answers Already Passed When driving on grades or slopes, if you have no traction? You have no forward motion. You are driving on 25% Side Slope when your downhill tires sink into softer dirt than your uphill tires. What might happen to the vehicle? The slope angle is increased, making roll- over more likely. You are traversing a side slope when your downhill tires begin to sink in soft soil. You can feel your uphill tires beginning to get light and lose traction. What do you do to counter this condition? Steer downhill to stabilize the vehicle and apply gentle momentum if necessary. If forward motion is stopped because of loss of traction while ascending a grade, what CTIS setting action do you take to increase traction and complete the ascent? MSS - Mud/Sand/Snow You are descending a long steep grade. You are using the vehicle brakes to control your speed. Traction doesn't seem to be a problem. What other options can you do to help control your descent speed? Use the exhaust brake downshift gear. What Line Lock setting will you be in when ascending up to 60% Grade? LL3 - Line Lock 3 What steps should you do before climbing any grade? Assess the terrain, Choose the safest path, Choose the proper gear before starting up the grade. When driving over obstacles or gullies, what should you do if you lose momentum or wheels start to spin? Use the BTM (Break Throttle Modulation). What is the Approach Angle This is the maximum angle of a ramp or obstacle onto which a JLTV can climb from a horizontal plane without interference. What is the Departure Angle The angle between the ground and the line drawn between the rear tire and the lowest handing part of the JLTV at the rear overhand. What is the Break-Over Angle The maximum possible supplementary that a JLTV with at least one forward wheel and one rear wheel can drive over without the apex of that angle touching any point. Which of the following does NOT need to be configured before maneuvering over obstacles? SAES How do you engage SAES Place the vehicle on Neutral (N). Set Parking Breaks on. Press SUSPENSION on the HOME Screen. Press RIDE HEIGHT ADJUST. Press SAES to adjust suspension for egress. Torsion can damage the? Drive Shaft When using the transaxle, what does the Low Range provide? Provides Torque for hill climbing ability When using the transaxle, what does the High Range provide? Used in normal conditions and allows for higher speeds. When switching High/Low Range on the transaxle, can it be completed while moving? No, the vehicle must be at a complete stop to engage or disengage the HI/LO Transaxle. When fording, the JLTV is limited to what speed? 10 MPH