CCNA 1 Final Exam Questions And Answers Rated A+ New Update Assured Satisfaction

Which of the following are the address ranges of the private IP addresses? (Choose three.) - Answer- 10.0.0.0 to 10.255.255.255 ; 172.16.0.0 to 172.31.255.255; 192.168.0.0 to 192.168.255.255 Which two functions of the OSI model occur at layer two? (Choose two.) - Answer-physical addressing ; media access control Refer to the exhibit. What function does router RT_A need to provide to allow Internet access for hosts in this network? - Answer-address translation What is true regarding network layer addressing? (Choose three.) - Answer-It uses a hierarchical structure.; uniquely identifies each host; A portion of the address is used to identify the network. Refer to the exhibit. Host A attempts to establish a TCP/IP session with host C. During this attempt, a frame was captured with the source MAC address 0050.7320.D632 and the destination MAC address 0030.8517.44C4. The packet inside the captured frame has an IP source address 192.168.7.5, and the destination IP address is 192.168.219.24. At which point in the network was this packet captured? - Answer-Leaving Dallas Refer to the exhibit. Assume all devices are using default configurations. How many subnets are required to address the topology that is shown? - Answer-3 A technician is asked to secure the privileged EXEC mode of a switch by requiring a password. Which type of password would require this login and be considered the most secure? - Answer-enable secret Refer to the exhibit. A technician is working on a network problem that requires verification of the router LAN interface. What address should be pinged from this host to confirm that the router interface is operational? - Answer-192.168.254.1Which OSI layer does IP rely on to determine whether packets have been lost and to request retransmission? - Answer-transport When connectionless protocols are implemented at the lower layers of the OSI model, what is usually used to acknowledge that the data was received and to request the retransmission of missing data? - Answer-an upper-layer, connection-oriented protocol or service Refer to the exhibit. Host C is able to ping 127.0.0.1 successfully, but is unable to communicate with hosts A and B in the organization. What is the likely cause of the problem? - Answer-The subnet mask on host C is improperly configured. Refer to the exhibit. Which list refers only to end devices? - Answer-D,E,F,G Refer to the exhibit. Host A sends a frame with the destination MAC address as FFFF.FFFF.FFFF. What action will the switch take for this frame? - Answer-It will send the frame to all hosts except host A. Which subnet mask will allow 2040 hosts per subnet on the IP network 10.0.0.0? - Answer- 255.255.248.0 Refer to the exhibit. RouterB is configured properly. The Ethernet interface Fa0/0 of RouterA is configured with the use of the commands that are shown. However, a ping from the Fa0/0 interface of RouterA to the Fa0/0 interface of RouterB is unsuccessful. What action should be taken on RouterA to solve this problem? - Answer-Use the no shutdown command on the FastEthernet interface Fa0/0. To send data through a network, what two flags are used to establish a session? (Choose two.) - Answer-ACK; SYN Which statement is true about the TTL value of an IPv4 packet? - Answer-It specifies the remaining "life" of the packet. Refer to the exhibit. Communication for hosts X and Y is restricted to the local network. What is the reason for this? - Answer-The gateway addresses are broadcast addresses.