Update) Questions and Verified Answers
100% Correct {Grade A}
Hydro elevators in low rise applications do not need an _____ _____ room. - correct
answer overhead machine
Some advantages of hydros are lower equipment and building construction costs
because the load of a hydro is carried to the _____ where as the load of a traction car
is carried by the _____ _____. - correct answer ground, building structure
When drilling the jack hole, the only proper way to determine if the hole is plumb is
to remove the drill stem and bit and use a _____ _____. - correct answer Spider Bob
To plumb the hole, a spider bob is attached to a length of piano wire suspended from
as near as possible to the top of the _____ or from a fixed point on the drill rig. -
correct answer Hoistway
When welding a joint, lay _____ inch tack welds _____ degrees apart, shift it 90 degrees
and lay two more 1 inch tack welds 180 degrees apart. - correct answer 1, 180
On power units having the motor beneath the tank, the pump may be either _____
driven or _____ coupled. - correct answer belt, direct
, NEIEP 800 Final Exam (Latest
Update) Questions and Verified Answers
100% Correct {Grade A}
The purpose of the _____/_____ is to silence the effect of any pulsations in the pump
output and should be as close to the pump as possible. - correct answer silencer,
muffler
On Bolsters/Bolster Assembly, the plunger is fastened to the _____ _____ which is then
mounted to the center of the Bolster Assembly. - correct answer platen plate
With wye-delta, reduced current starting is accomplished without the need for _____. -
correct answer resistors
_____ run buttons should run the platform and sling at leveling speeds only. - correct
answer Temporary
A _____ _____ consists of a piston held closed by an adjustable spring and must open at
a certain pressure to prevent any further increase in pressure. - correct answer relief
valve
A _____ lowering valve allows the car to be lowered at a speed not exceeding 20fpm in
case of power failure. - correct answer manual