60M Ground School concISE hIGh YIEld ExaM QuESTIonS and 100% corrEcT anSWErS|| uPdaTEd 2026/2027 SYllaBuS|| 100% GuaranTEEd PaSS||alrEadY GradEd a+||<laTEST VErSIon>

How many waypoints can be put into a flights plan? - ANSWER 99 How many "store points" can be captured? - ANSWER 25 IG2 indicated what navigation solution? - ANSWER Blended GPS and inertial nav from #2 EGI What does the "STS" annunciation display at the top of the FMS mean? - ANSWER a change in status has occured A box around a parameter on any given screen indicated what? - ANSWER that a parameter may be edited Manual selection of the aircraft navigation solution can be acomplished by accessing which FMS page? - ANSWER EGI page How can you quickly capture a target store point? - ANSWER press the FIX fixed function key twice How is FLPN-A or FLPN-B initiated? - ANSWER FLPN fixed function key, edit, engage, confirm Which page allows the pilot to change the com data/frequency assigned to a specific preset? - ANSWER DAT (mission data page) fixed function key What is the purpose of the flight plan sequence next function when in the auto mode? - ANSWER allows the operator to sequence to the course between the next pair of waypoints Steering cues are processed/commanded by what components? - ANSWER the FCC's What does the TAC MAP display provide? - ANSWER Tactical situational awareness information Selecting _____ from the menu accesses the symbol, graphic, or waypoint data as appropriate, for the hooked item. - ANSWER DATA The map annunciation block displays what two types of annunciations? - ANSWER Caution and or Advisory - ANSWER Select (index finger), Menu (middle finger) and Mode (ring finger) Pressing the MFSC ______________ button while the cursor is in Free Cursor Mode will cause an edit menu to appear - ANSWER Select The cursor box displays the geo-referenced coordinates of the cursor position. The cursor box will be displayed in either _____________________ units as comanded by the on-side FMS. - ANSWER Lat/Long or MGRS When the Free Cursor is adjacent to a bezel key, it changes from white to ___________. Pressing the MFSC select switch is interpreted as a press of the bezel key which the cursor is adjacent to. - ANSWER Cyan To engage the HVR VHLD mode the airspeed must be below ___________? - ANSWER 60 KIAS The GO ARND button establishes what two parameters? - ANSWER 750fpm rate of climb and 70 KIAS To engage the aircraft level attitude recovery mode when in an unusual attitude, the aircraft must be above _____ knots - ANSWER 60 ____________ toggles the map orientation through heading up (HDG), North Up (North) and Track up (TRK). ______________ is the default mode. - ANSWER ORIENT, Heading UP You can select ADD or INSERT on the ______________ edit menu - ANSWER waypoint What functions does the CSC (collective slew controller) have? - ANSWER slew and select function __________________ is provided in the symbol and waypoint edit menus when an item is ___________ and more than one item is within 0.5 - ANSWER NEXT, HOOKED What are the 3 push buttons located on the Multi Function Slew Controller (MFSC)? The Active Cursor can be switched between onside MFDs by means of the _______ _____ icon. - ANSWER screen jump tactical map modes uses ________ and ____________ bezel keys to provide map manipulation controls - ANSWER left and upper the MFD provides control of the ASE threat shading on all tactical map underlays when the __________ is turned on - ANSWER TIV What are the two types of frame files? - ANSWER Data frames (i.e. approach plates) and Captures frames (i.e. screensaves) How do you access the data frame sub menu? - ANSWER Selection of FRAME from the map mode sub-menu will access the data frame sub-menu the default free cursor is displayed on the TAC MAP as a? - ANSWER white crosshair While the FMS is configured for Lat/Long the range ring distance readouts will be displayed in? - ANSWER NM Range Rings are only displayed while the map is in __________ mode. - ANSWER Dynamic The panning function is only available in the _____________ mode. - ANSWER Static The cautions/advisories in the CAWS box on the TAC page appear in what order? - ANSWER Chronological PCMCIA stands for? - ANSWER Personal Computer Memory Card International Association PMCIA must be inserted how? - ANSWER With pins down and label facing aft The USER partition of the DTS is used for? - ANSWER File management Flashing status indicator light on the DTU indicates what? - ANSWER The card is writing, copying or updating information To load data from the card into the FMS, select SK-10, DTS on: - ANSWER INI 1/3 Max Gross weight of the UH60M - ANSWER 22,000 lbs ALuminum paneling is used for E3 protection. Where this cannot be used, _________________ is used. - ANSWER Aluminum mesh What is the minimum crew for the 60M? - ANSWER two; pilot and copilot Which flight control computer is located in the nose? - ANSWER #2 FCC The wide chord blade has what type of spar? - ANSWER graphite epoxy The landing gear is designed to absorb a landing rate of up to how many feet per second? - ANSWER 39 fps For flights over 6 hours engine oil level should be - ANSWER at the full mark What provides pneumatic power for main engine start, cabin heating and electrical power for ground operations and in flight emergency electrical power? - ANSWER The Auxiliary Power Unit (APU) The main transmission has a built in ____ degree tilt - ANSWER 3 degree The cargo hook is used to carry external loads of up to _________? - ANSWER 9,000 lbs Accumulator pressure guage should read what for APU starting? - ANSWER 2,800 PSI What changes the direction, transmits torque, and reduces shaft speed from the main gear box to the tail rotor gear box? - ANSWER Intermediate Gear Box The tail wheel swivels _____ degrees on a yoke assembly when unlocked. - ANSWER 360 degrees The bottom trailing edge of the tail pylon has an aerodynamically shaped fairing, with a ____ degree camber to decrease the amount of tail rotor pitch/anti-torque required in forward flight. - ANSWER 7 degrees The helicopter has a variable angle of incidence ______ to enhance handling qualities. - ANSWER stabilator Where is the #1 FCC located? - ANSWER Aft avionics compartment Why should you not store any items below the pilot seats? - ANSWER any obstruction will increase the probability and severity of injury What is the purpose of the reversionary switch panel? - ANSWER provides a means of manually selecting data sources for the pilot and copilot MFD's How are the MFD's numbered? - ANSWER 1-4 from left to right The digital clock has an internal battery that will keep functioning for how long? - ANSWER One year What is the purpose of the Auxiliary Fuel Management Panel - ANSWER It contains all controls for operating the Crashworthy External Fuel System (CEFS) How can the tailwheel be locked in the trail position? - ANSWER the TAIL WHEEL switch in the cockpit indicating LOCK or UNLKD Where are the controls to operate the Common Missile Warning System from the cockpit? - ANSWER The dispenser control panels located on the lower console contains all controls to operate the CMWS system What are the 4 positions of the Engine Power Control (PCL) called? - ANSWER OFF, IDLE, FLY, LOCKOUT How is cockpit ventilation controlled? - ANSWER Ventilation is controlled through a switch on the upper console marked VENT BLOWER How many fire extinguisher handles are on the aircraft? - ANSWER Two on the engine control quadrant and one APU T-handle on the APU control panel The ICS system consists of how many panels located throughout the cabin - ANSWER Five How many modes are there available in the ICS system? - ANSWER Four What does the ICS consist of? - ANSWER The ICU (interface control unit), five ICS control panels, and cyclic and collective switches The CVR is used primarily for what? - ANSWER Accident investigation The acoustic beacon will emanate a signal for how long? - ANSWER 30 days When the main transmission oil pressure is normal (&gt;20psi) the CVR/FDR will _______? - ANSWER start recording What kind of protection is offered to the pilot and copilot against small arms? - ANSWER Armor plating resistant up to 7.62mm The VLEA's may be manually adjusted for occupants ranging in weight from? - ANSWER 130lbs to 250lbs How can the Martin Baker seat be adjusted? - ANSWER left right forward or aft What is the purpose of the inertia reels on the seat back and bottom? - ANSWER it gives the wearer freedom to move about his station how many passengers will the 60M accommodate in a seats in configuration, not including crew members? - ANSWER 11 What are the two types of restraints offered to passengers in the UH-60M? - ANSWER Belt and Shoulder harnesses What does the FMDS consist of? - ANSWER MFD's, Reversionary Switch Panel, EFIS (electronic flight instrument system), MFSC's (multi function slew controllers) The outboard #1 and #4 MFD's will default to _____ and the inboard #3 and #4 MFD's will default to _______ - ANSWER PFD, EICAS The reversionary switch panels allow the pilot and copilot to? - ANSWER Choose an alternate data source to display information on their MFD's What do the MFSC's provide? - ANSWER Control of the MFD Cursor, Cursor Activation, Menu Navigation & Selection MFD display control and submodes are controlled using what? How many are there? - ANSWER Bezel keys, 24 per MFD (6 per side) The PFD _____________________ annunciations are displayed as a yellow parameter label with a double-headed arrow above. - ANSWER miscompare Where is the stabilator position indicator found? - ANSWER top left corner of the PFD What colors will the stabilator indicator display in? what do they mean? - ANSWER White = auto mode and limited auto mode Yellow = manual mode An input failure of the airspeed data will result in what being displayed? - ANSWER a red IAS fail flag The pitch and roll attitude inputs to the PFD are provided by what? - ANSWER the EGI's When does the standard deviation scale on the PFD change to an expanded scale? - ANSWER When a localizer frequency is tuned