Page 1 of 67
CTS-I EXAM QUESTIONS AND CORRECT VERIFIED
ANSWERS LATEST UPDATE JUST RELEASED THIS
YEAR
Question: Which mounting hardware will provide the MOST support when mounting a camera
bracket to sheetrock/plasterboard not located near a wall stud?
a. Self tapping screws
b. Plastic wall anchors / wall plugs
c. Snap toggles / hollow wall anchors
d. Masonry bolts - ANSWER✔✔c. Snap toggles / hollow wall anchors
Question: When mounting a 75lb (34 kg) projector with a 15lb (7 kg) mount, the substructure
should be able to support a minimum of:
a. 180lbs (82 kg)
b. 90lbs (41 kg)
c. 450lbs (204 kg)
d. 270lbs (122 kg) - ANSWER✔✔c. 450lbs (204 kg)
1
SUCCESS!
,Page 2 of 67
Question: When making a 2 inch hole in a piece of thin sheet metal, what is the BEST tool to
use.
a. Stepped drill bit
b. Carbide drill bit
c. Metal punch
d. Hole saw - ANSWER✔✔c. Metal punch
Question: Heat dissipated by equipment in an AV rack is measured in:
a. Degrees
b. Coulombs
c. BTU/H
d. Watts - ANSWER✔✔c. BTU/H
Question: Where do you place the wireless microphone receiver antenna in a rack assembly?
a. Close to the transmitter
2
SUCCESS!
,Page 3 of 67
b. Inside the room
c. Outside the rack
d. Inside the rack - ANSWER✔✔c. Outside the rack
Q:What is the total impedance (rounded) of 10 loudspeakers tapped at 7.5w each in a 70v,
distributed system?
a. 128 ohms
b. 80 ohms
c. 65 ohms
d. 8 ohms - ANSWER✔✔c. 65ohms
Question: An amplifier can supply 100w at 2 ohms. How many 8 ohm speakers can be wired in
parallel without exceeding the capabilities of amplifier?
a. 2
b. 3
3
SUCCESS!
, Page 4 of 67
c. 1
d. 4 - ANSWER✔✔d. 4
Question: Before audiovisual equipment can be brought to a site what MUST occur?
a. General contractor must obtain a CO
b. The site must be clean and dust free
c. All cable must be installed
d. The rack must be wired - ANSWER✔✔b. The site must be clean and dust free
Question: Which device is used to verify signal integrity throughout a video system?
a. A volt meter to check resistance
b. A multi-meter
c. A Video Optimization meter (VOM)
d. A video test generator (VTG) - ANSWER✔✔d. A video test generator (VTG)
4
SUCCESS!
CTS-I EXAM QUESTIONS AND CORRECT VERIFIED
ANSWERS LATEST UPDATE JUST RELEASED THIS
YEAR
Question: Which mounting hardware will provide the MOST support when mounting a camera
bracket to sheetrock/plasterboard not located near a wall stud?
a. Self tapping screws
b. Plastic wall anchors / wall plugs
c. Snap toggles / hollow wall anchors
d. Masonry bolts - ANSWER✔✔c. Snap toggles / hollow wall anchors
Question: When mounting a 75lb (34 kg) projector with a 15lb (7 kg) mount, the substructure
should be able to support a minimum of:
a. 180lbs (82 kg)
b. 90lbs (41 kg)
c. 450lbs (204 kg)
d. 270lbs (122 kg) - ANSWER✔✔c. 450lbs (204 kg)
1
SUCCESS!
,Page 2 of 67
Question: When making a 2 inch hole in a piece of thin sheet metal, what is the BEST tool to
use.
a. Stepped drill bit
b. Carbide drill bit
c. Metal punch
d. Hole saw - ANSWER✔✔c. Metal punch
Question: Heat dissipated by equipment in an AV rack is measured in:
a. Degrees
b. Coulombs
c. BTU/H
d. Watts - ANSWER✔✔c. BTU/H
Question: Where do you place the wireless microphone receiver antenna in a rack assembly?
a. Close to the transmitter
2
SUCCESS!
,Page 3 of 67
b. Inside the room
c. Outside the rack
d. Inside the rack - ANSWER✔✔c. Outside the rack
Q:What is the total impedance (rounded) of 10 loudspeakers tapped at 7.5w each in a 70v,
distributed system?
a. 128 ohms
b. 80 ohms
c. 65 ohms
d. 8 ohms - ANSWER✔✔c. 65ohms
Question: An amplifier can supply 100w at 2 ohms. How many 8 ohm speakers can be wired in
parallel without exceeding the capabilities of amplifier?
a. 2
b. 3
3
SUCCESS!
, Page 4 of 67
c. 1
d. 4 - ANSWER✔✔d. 4
Question: Before audiovisual equipment can be brought to a site what MUST occur?
a. General contractor must obtain a CO
b. The site must be clean and dust free
c. All cable must be installed
d. The rack must be wired - ANSWER✔✔b. The site must be clean and dust free
Question: Which device is used to verify signal integrity throughout a video system?
a. A volt meter to check resistance
b. A multi-meter
c. A Video Optimization meter (VOM)
d. A video test generator (VTG) - ANSWER✔✔d. A video test generator (VTG)
4
SUCCESS!
