Exam 955 MSS - TEST 1 QUESTIONS
AND ANSWERS 100% PASS
What is the raised part of a shaft called?
A. Bearing
B. Crown
C. Shoulder
D. Shelf - CORRECT ANSWER-Shoulder
What type of bearing should not be greased?
A. a roller bearing
B. a seal bearing
C. a ball bearing
D. a bad bearing - CORRECT ANSWER-A permanent seal bearing - brass
bushings should not be greased
, Would you seat a bearing by using outer or inner surface?
A. inner, with a brass hammer
B. inner, with an arbor press
C. outer
D. none of the above - CORRECT ANSWER-By applying pressure to the
OUTER surface
Why are key ways placed on a shaft?
A. to keep the pulley or gear from turning on the shaft
B. so you can unlock them
C. So another shaft can interlock with the first shaft
D. So the key stock has a place to go - CORRECT ANSWER-To keep a pulley or
a gear from turning on the shaft
What is the name of a key that is placed in the keyway that has one side flat and the
other side rounded?
A. Key stock
COPYRIGHT ALL RIGHTS RESERVED ©️ 2025
AND ANSWERS 100% PASS
What is the raised part of a shaft called?
A. Bearing
B. Crown
C. Shoulder
D. Shelf - CORRECT ANSWER-Shoulder
What type of bearing should not be greased?
A. a roller bearing
B. a seal bearing
C. a ball bearing
D. a bad bearing - CORRECT ANSWER-A permanent seal bearing - brass
bushings should not be greased
, Would you seat a bearing by using outer or inner surface?
A. inner, with a brass hammer
B. inner, with an arbor press
C. outer
D. none of the above - CORRECT ANSWER-By applying pressure to the
OUTER surface
Why are key ways placed on a shaft?
A. to keep the pulley or gear from turning on the shaft
B. so you can unlock them
C. So another shaft can interlock with the first shaft
D. So the key stock has a place to go - CORRECT ANSWER-To keep a pulley or
a gear from turning on the shaft
What is the name of a key that is placed in the keyway that has one side flat and the
other side rounded?
A. Key stock
COPYRIGHT ALL RIGHTS RESERVED ©️ 2025