Week 4 Midterm Exam
Due Jun 9 at 11:59pm
Points 35
Questions 35
Available May 13 at 12am - Jun 10 at 11:59pm
Time Limit None
Instructions
• Quizzes must be completed and submitted by Sunday 11:59 PM of the week in
which they are due. There are no exceptions. The quizzes cannot be opened
after the due date has passed, not even by faculty or student success coaches.
Requests to open quizzes to complete them after the due date will not be
considered.
• You have only ONE attempt at completing a quiz. Quizzes cannot be reset for
multiple attempts.
This quiz was locked Jun 10 at 11:59pm.
Attempt History
Attempt Time Score
LATEST Attempt 1 25 minutes 35 out of 35
Score for this quiz: 35 out of 35
Submitted Jun 5 at 6:03pm
This attempt took 25 minutes.
Question 1
pts
Which of the following parts may not be present in older single-action firearms?
Loading gate
Firing pin
Cylinder
Correct!
Transfer bar
Your answer is correct.
https://classroom.sdi.edu/courses/5933/quizzes/47670?module_item_id=345991 1/15
, 6/29/24, 11:00 AM Week 4 Midterm Exam: FTT 111 Firearms Inspection and Troubleshooting
Page 98, Paragraph 3
Even newer single-action revolver designs will utilize a part known as a transfer bar. The transfer bar is
used as a type of automated safety, which prevents accidental discharge.
Question 2
pts
What is the general measured range of cylinder gap in a double action revolver?
Between .001 and .003
Between .005 and .016
Correct!
Between .003 and .013
Between .007 and .020
Your answer is correct.
Question 3
pts
Which safety feature is included on a firing pin that is included in the frame of a double action revolver?
Correct!
Transfer bar
Hammer block
Falling block
Grip safety
Your answer is correct.
Question 4
pts
The locking step of the double-action revolver happens when the hammer is in the cocked position.
Correct!
True
False
Question 5
pts
If the spring that drives the cylinder bolt is damaged or worn, the cylinder may:
https://classroom.sdi.edu/courses/5933/quizzes/47670?module_item_id=345991 2/15