Mississippi Residential Builder License Exam Prep –
Full Review & Test Bank real exam!!!
To screw gypsum panels to 18 gage steel studs, you should use what type of screw? - ANSWER ✔---
S-12
A mil gage is used to verify___________. - ANSWER ✔---coating thickness
A contractor is building a 40' x 24' single story house with a 6/12 straight gable roof and a 96" from sole
plate to top plate. How many 4' x 8' sheets of wall sheathing are required. Do not deduct openings or
add waste. - ANSWER ✔---37
What item is not part of an exterior frame wall - ANSWER ✔---Bridging
Where is the base flashing installed when using brick veneer for the outside finish over wood frame
walls? - ANSWER ✔---Between the sheathing paper and the wood sheathing, extending into the
mortar joint at the brick course below the bottom of the sheathing.
What angle does the valley rafter form with the main ridge board in a roof of uniform pitch? -
ANSWER ✔---45
, What is the rafter run for a straight gable roof with a span of 36'? - ANSWER ✔---18'
In what section of the construction manual with information on artifacts be likely shown? -
ANSWER ✔---Supplemental
What is the type of roofing in which skip sheathing is used? - ANSWER ✔---Wood shingles and
shakes
Carpentry & Building Construction
Page 565
The windows manufacturer's catalog will contain a sizing table with what measurements? -
ANSWER ✔---Masonry opening, rough opening, frame size, glass size, and occasionally sash size
Carpentry & Building Construction
page 586
When placing insulation in an existing home what is the best installation method? - ANSWER ✔---
Loose-fill
Carpentry & Building Construction
page 898
How does batt insulation located under the floor joist stay in place? - ANSWER ✔---Wire mesh or
rigid board
Carpentry & Building Construction
page 904-905
Drywall can cover wall cavities once the moisture content of the insulation drops to less than? -
ANSWER ✔---19%
Carpentry & Building Construction
page 899
Full Review & Test Bank real exam!!!
To screw gypsum panels to 18 gage steel studs, you should use what type of screw? - ANSWER ✔---
S-12
A mil gage is used to verify___________. - ANSWER ✔---coating thickness
A contractor is building a 40' x 24' single story house with a 6/12 straight gable roof and a 96" from sole
plate to top plate. How many 4' x 8' sheets of wall sheathing are required. Do not deduct openings or
add waste. - ANSWER ✔---37
What item is not part of an exterior frame wall - ANSWER ✔---Bridging
Where is the base flashing installed when using brick veneer for the outside finish over wood frame
walls? - ANSWER ✔---Between the sheathing paper and the wood sheathing, extending into the
mortar joint at the brick course below the bottom of the sheathing.
What angle does the valley rafter form with the main ridge board in a roof of uniform pitch? -
ANSWER ✔---45
, What is the rafter run for a straight gable roof with a span of 36'? - ANSWER ✔---18'
In what section of the construction manual with information on artifacts be likely shown? -
ANSWER ✔---Supplemental
What is the type of roofing in which skip sheathing is used? - ANSWER ✔---Wood shingles and
shakes
Carpentry & Building Construction
Page 565
The windows manufacturer's catalog will contain a sizing table with what measurements? -
ANSWER ✔---Masonry opening, rough opening, frame size, glass size, and occasionally sash size
Carpentry & Building Construction
page 586
When placing insulation in an existing home what is the best installation method? - ANSWER ✔---
Loose-fill
Carpentry & Building Construction
page 898
How does batt insulation located under the floor joist stay in place? - ANSWER ✔---Wire mesh or
rigid board
Carpentry & Building Construction
page 904-905
Drywall can cover wall cavities once the moisture content of the insulation drops to less than? -
ANSWER ✔---19%
Carpentry & Building Construction
page 899
