AZ Floor Covering Contractors
License (Classification: CR-8)
#15 asphalt-lined paper - ANS-After cleaning the subfloor, what is the first thing you do when
installing all rightstrip flooring over a 3/4-inch plywood subfloor? 1 inch is 1 foot. ANS: On the
same set of drawings, which scale could show the maximum element? Machine-driven
1-1/2-inch fastener - ANS-When putting in tongue-and-groove (T&G) flooring this is half inch
thick by means of 2 inch wide, which of the subsequent should be used? 1-3 weeks -
ANS-According to the NOFMA, how a lot time should be allowed for a stable strip ground to
acclimate before intending with sanding and completing the operation?
1-three/sixteen inches & 2-eleven/16 inches - ANS-What is the endorsed quantity of distance to
stretch carpet in a room 10 toes wide via 15 feet lengthy? (Stretch 1% to one-half of% in
duration and width)
1/2 - ANS-When applying adhesive to put VCT (Vinyl Composite Tile), the adhesive must be
applied to ____ of the work place.
Half the depth - ANS-When re-grouting tile, how a good deal vintage grout need to you put off?
1/four - ANS-When putting quarry tile on fresh set dust you must go away the grout joints how
deep?
1/four inch ANS: When installing underlayment, how plenty area must remain among the wall
and the underlayment? 1/4 inch - ANS-When putting in underlayment, how a great deal gap
have to be left between the underlayment and the wall?
1/4 inch - ANS-The grout joints should be left how deep whilst setting quarry tile on freshly set
dust? 1/4 inch in 10 ft - ANS-A vertical wall, what is the acceptable tolerance for being plumb?
1/8 inch hole among the sheets and a 1/2 inch hole alongside the partitions - ANS-3/four inch
below-layment technique plywood subfloor for a parquet ground should be installed with:
1/eight inch gap among the sheets and a half inch gap between the walls - ANS-three/4 inch
underlaymnet technique plywood subfloor for a parquet floor must be mounted with?
1/eight inch on ends and edges - ANS-When applying plywood sub-floors the minimal spacing
between adjoining panels at the edge is?
10 - ANS-When blind nailing 6ft plank flooring, how many nails are used in keeping with plank?
10-12 inches - ANS-When installing hardwood strip tongue and groove flooring, nail need to be
positioned how a ways apart?
15 pound roofing felt or four mil polyethylene - ANS-Ceramic tile is to be established the usage
of the "one coat" approach over gypsum board on timber studs; the "Tile Council of America"
recommends that the membrane be:
15 pound tar paper - ANS-According to "Setting Ceramic Tile", which of the following is the nice
desire for use as a curling membrane, underneath a floated mortar bed in a dry area?
15° tiers - ANS-For stretching carpet, what perspective do you location the stretcher in the
direction of the alternative corner?
, 15lb felt paper - ANS-Before nailing wooden flooring down on plywood sub-ground, what do
you placed down?
16d - ANS: What type of 1/4-inch-thick nails do you use to restore a loose subfloor? 1984 -
ANS-Asbestos became used as a binder in most materials as much as what year?
1985 - ANS-Tile adhesive may include asbestos if synthetic before what yr?
1985 - ANS-When eliminating antique linoleum, it is able to contain asbestos if manufactured
before?
2 - ANS-When positioning carpet in guidance for seaming, there must be an overlap of ____
inches?
2 inch backer-board screws at edges and 1-1/four inch in field - ANS-To connect cement
backer-board to a sub-ground, what minimal duration of screws must be used?
2 inch, #12 timber screws - ANS-A strip and plank border need to be mounted to the sub-floor
using?
2 beginning rows and 4 finishing rows - ANS-Finding sufficient instantly portions for how many
starters and finishers is one of the first things to do earlier than laying the ground. 24 - ANS-How
many hours must you wait before grouting after the usage of natural adhesive?
24 hours - ANS-After the set up of parquet floor (expect pre-completed & glued down), how
long earlier than fixtures can be set at the floor?
24 hours - ANS-How long have to carpet be left within the surroundings wherein it's far to be
mounted, before being mounted?
24 hours - ANS: Prior to installing carpet, how lengthy ought to a calcium chloride test be
examine? Three - ANS-To reduce a straight seam when installing sheet vinyl flooring, overlap
the vinyl sheets ____ inches.
Three inches - ANS-To cut a straight seam in a non-patterned sheet vinyl, overlap the sheets:
three/eight inch - ANS-The minimal outside enlargement joint width for joints 12 foot on middle
is:
3/eight inch - ANS-When putting in carpet, the most gutter among the wall and the tack-less
strip will be:
3/8 inch - ANS-When putting in carpet, the maximum gutter among the wall and the tackless
strip shall no be more than:
four companies - ANS-The marble institute of America has categorized marble and stone into
what number of corporations?
Four inches - ANS-How a great deal need to the rims of below-layment overlap beneath a
wood ground?
Four% - ANS-Before gluing flooring to a sub-ground the distinction in moisture content material
between the flooring and the sub-ground should no longer be greater than:
45 to 50 degree - ANS-Hardwood floors is nailed in vicinity with the nail pushed at about a ____
perspective to the ground
45° diploma perspective - ANS-When laying tile on a diagonal, what attitude do you use for the
layout line?
Forty eight - ANS-Linoleum needs a duration of acclimatization earlier than laying, up to ____
hours at room temperature.
48 - ANS-Linoleum needs a length of acclimatization earlier than laying, as much as ____
hours at room temperature.
License (Classification: CR-8)
#15 asphalt-lined paper - ANS-After cleaning the subfloor, what is the first thing you do when
installing all rightstrip flooring over a 3/4-inch plywood subfloor? 1 inch is 1 foot. ANS: On the
same set of drawings, which scale could show the maximum element? Machine-driven
1-1/2-inch fastener - ANS-When putting in tongue-and-groove (T&G) flooring this is half inch
thick by means of 2 inch wide, which of the subsequent should be used? 1-3 weeks -
ANS-According to the NOFMA, how a lot time should be allowed for a stable strip ground to
acclimate before intending with sanding and completing the operation?
1-three/sixteen inches & 2-eleven/16 inches - ANS-What is the endorsed quantity of distance to
stretch carpet in a room 10 toes wide via 15 feet lengthy? (Stretch 1% to one-half of% in
duration and width)
1/2 - ANS-When applying adhesive to put VCT (Vinyl Composite Tile), the adhesive must be
applied to ____ of the work place.
Half the depth - ANS-When re-grouting tile, how a good deal vintage grout need to you put off?
1/four - ANS-When putting quarry tile on fresh set dust you must go away the grout joints how
deep?
1/four inch ANS: When installing underlayment, how plenty area must remain among the wall
and the underlayment? 1/4 inch - ANS-When putting in underlayment, how a great deal gap
have to be left between the underlayment and the wall?
1/4 inch - ANS-The grout joints should be left how deep whilst setting quarry tile on freshly set
dust? 1/4 inch in 10 ft - ANS-A vertical wall, what is the acceptable tolerance for being plumb?
1/8 inch hole among the sheets and a 1/2 inch hole alongside the partitions - ANS-3/four inch
below-layment technique plywood subfloor for a parquet ground should be installed with:
1/eight inch gap among the sheets and a half inch gap between the walls - ANS-three/4 inch
underlaymnet technique plywood subfloor for a parquet floor must be mounted with?
1/eight inch on ends and edges - ANS-When applying plywood sub-floors the minimal spacing
between adjoining panels at the edge is?
10 - ANS-When blind nailing 6ft plank flooring, how many nails are used in keeping with plank?
10-12 inches - ANS-When installing hardwood strip tongue and groove flooring, nail need to be
positioned how a ways apart?
15 pound roofing felt or four mil polyethylene - ANS-Ceramic tile is to be established the usage
of the "one coat" approach over gypsum board on timber studs; the "Tile Council of America"
recommends that the membrane be:
15 pound tar paper - ANS-According to "Setting Ceramic Tile", which of the following is the nice
desire for use as a curling membrane, underneath a floated mortar bed in a dry area?
15° tiers - ANS-For stretching carpet, what perspective do you location the stretcher in the
direction of the alternative corner?
, 15lb felt paper - ANS-Before nailing wooden flooring down on plywood sub-ground, what do
you placed down?
16d - ANS: What type of 1/4-inch-thick nails do you use to restore a loose subfloor? 1984 -
ANS-Asbestos became used as a binder in most materials as much as what year?
1985 - ANS-Tile adhesive may include asbestos if synthetic before what yr?
1985 - ANS-When eliminating antique linoleum, it is able to contain asbestos if manufactured
before?
2 - ANS-When positioning carpet in guidance for seaming, there must be an overlap of ____
inches?
2 inch backer-board screws at edges and 1-1/four inch in field - ANS-To connect cement
backer-board to a sub-ground, what minimal duration of screws must be used?
2 inch, #12 timber screws - ANS-A strip and plank border need to be mounted to the sub-floor
using?
2 beginning rows and 4 finishing rows - ANS-Finding sufficient instantly portions for how many
starters and finishers is one of the first things to do earlier than laying the ground. 24 - ANS-How
many hours must you wait before grouting after the usage of natural adhesive?
24 hours - ANS-After the set up of parquet floor (expect pre-completed & glued down), how
long earlier than fixtures can be set at the floor?
24 hours - ANS-How long have to carpet be left within the surroundings wherein it's far to be
mounted, before being mounted?
24 hours - ANS: Prior to installing carpet, how lengthy ought to a calcium chloride test be
examine? Three - ANS-To reduce a straight seam when installing sheet vinyl flooring, overlap
the vinyl sheets ____ inches.
Three inches - ANS-To cut a straight seam in a non-patterned sheet vinyl, overlap the sheets:
three/eight inch - ANS-The minimal outside enlargement joint width for joints 12 foot on middle
is:
3/eight inch - ANS-When putting in carpet, the most gutter among the wall and the tack-less
strip will be:
3/8 inch - ANS-When putting in carpet, the maximum gutter among the wall and the tackless
strip shall no be more than:
four companies - ANS-The marble institute of America has categorized marble and stone into
what number of corporations?
Four inches - ANS-How a great deal need to the rims of below-layment overlap beneath a
wood ground?
Four% - ANS-Before gluing flooring to a sub-ground the distinction in moisture content material
between the flooring and the sub-ground should no longer be greater than:
45 to 50 degree - ANS-Hardwood floors is nailed in vicinity with the nail pushed at about a ____
perspective to the ground
45° diploma perspective - ANS-When laying tile on a diagonal, what attitude do you use for the
layout line?
Forty eight - ANS-Linoleum needs a duration of acclimatization earlier than laying, up to ____
hours at room temperature.
48 - ANS-Linoleum needs a length of acclimatization earlier than laying, as much as ____
hours at room temperature.
