Smart-T Answers of Power
Study online at https://quizlet.com/_bi6h49
1. How long does the two 12-volt batteries auto- -for up to 1 minute
matically provide backup power to the SMART-T
during power losses and failures?
2. What does CRK stand for? -Cryptographic Recovery Key
3. Only the ROU and LID have power switches. False
4. What does the F in the stored key status legend future
stands for?.
5. A communications plan is not necessary when False
setting up a network and connecting the
SMART-T to a satellite.
6. Spot beams are most useful for what type of Small disadvantaged terminal
terminal?
7. When would you perform a warm start? -When all required mission data
and parameters are already prop-
erly stored in the terminal.
8. The purpose of the reflector is to collect and true
direct downlinks to the sub reflector and direct
uplink transmissions from the sub reflector to
the satellite.
9. True or False. The operator can manually activate true
each step for satellite acquisition.
10. List three safety warnings or precautions associ- -hot surfaces when operating
ated with the generator. -noise hazard
-fuels are highly explosive
1/8
, Smart-T Answers of Power
Study online at https://quizlet.com/_bi6h49
11. What is the difference when installing the ROU? It can be installed externally and
also in can be connected remotely
up to a mile with slash wire
12. A failure in a terminal automatically being joined true
to a network is not indicated to the operator by
an advisory or other message.
13. Where is the ground pad storage located? right of curbside storage container
14. What does LDR stand for? low data rate
15. Where is the auxiliary fuel stowage location? curbside front of SMART-T pallet
16. What is the purpose for using MILSTAR/AEHF To maintain a high degree of surviv-
satellites? ability under conditions of electron-
ic warfare and electronic detection.
17. From the standpoint of an OPERATOR the true
SMART-T is only dismounted from the HMMWV
if it will be in a mission environment for an ex-
tended period of time.
18. What power source do you plug into the J9 port The HMMWV
below the PDU?
19. what does the LID and LOD use to communicate slash wire
to the UIU?
20. You don't need to choose a Satellite ID for an false
request for keys.
21. What is the definition of an MDR Dual Simplex A full duplex network which sup-
network? ports only two members
2/8
Study online at https://quizlet.com/_bi6h49
1. How long does the two 12-volt batteries auto- -for up to 1 minute
matically provide backup power to the SMART-T
during power losses and failures?
2. What does CRK stand for? -Cryptographic Recovery Key
3. Only the ROU and LID have power switches. False
4. What does the F in the stored key status legend future
stands for?.
5. A communications plan is not necessary when False
setting up a network and connecting the
SMART-T to a satellite.
6. Spot beams are most useful for what type of Small disadvantaged terminal
terminal?
7. When would you perform a warm start? -When all required mission data
and parameters are already prop-
erly stored in the terminal.
8. The purpose of the reflector is to collect and true
direct downlinks to the sub reflector and direct
uplink transmissions from the sub reflector to
the satellite.
9. True or False. The operator can manually activate true
each step for satellite acquisition.
10. List three safety warnings or precautions associ- -hot surfaces when operating
ated with the generator. -noise hazard
-fuels are highly explosive
1/8
, Smart-T Answers of Power
Study online at https://quizlet.com/_bi6h49
11. What is the difference when installing the ROU? It can be installed externally and
also in can be connected remotely
up to a mile with slash wire
12. A failure in a terminal automatically being joined true
to a network is not indicated to the operator by
an advisory or other message.
13. Where is the ground pad storage located? right of curbside storage container
14. What does LDR stand for? low data rate
15. Where is the auxiliary fuel stowage location? curbside front of SMART-T pallet
16. What is the purpose for using MILSTAR/AEHF To maintain a high degree of surviv-
satellites? ability under conditions of electron-
ic warfare and electronic detection.
17. From the standpoint of an OPERATOR the true
SMART-T is only dismounted from the HMMWV
if it will be in a mission environment for an ex-
tended period of time.
18. What power source do you plug into the J9 port The HMMWV
below the PDU?
19. what does the LID and LOD use to communicate slash wire
to the UIU?
20. You don't need to choose a Satellite ID for an false
request for keys.
21. What is the definition of an MDR Dual Simplex A full duplex network which sup-
network? ports only two members
2/8
