FC ATT Week 11
__________ is the technique employed to fight ECM - ANS-ECCM
__________ is the transmitter feature that makes it tough for a jammer to synchronize with
the radar as a way to use repeater, variety-gate and speed-gate pull off, or fake target
generators - ANS-PRF
_____________ loss is due to high frequency currents flowing near the outer surface of the
conductor - ANS-Skin
______________ is due to the capacitance fashioned between transmission strains -
ANS-Dielectric
_______________ are the most commonly used mild supply for fiber optics - ANS-LED
_______________ are the end result of incorrect waveguide becoming a member of or
obstructions in waveguides - ANS-standing waves
_______________ is due to resistance, in particular in lengthy lines - ANS-Copper loss
_______________ is because of the expanding and collapsing magnetic fields inducing
voltage and modern surfaces near the transmission strains - ANS-Induction loss
_______________ transmission line allows the least velocity (60% of the rate of light) -
ANS-Twisted Pair
_________________ transmission line lets in the greatest RF velocity (ninety seven% of the
velocity of mild) - ANS-open 2-twine
_________________ makes use of the outer conductor to protect the center conductor. -
ANS-Coaxial
_____________________ can offer a effective condensed beam within a slender spectral
range, but are pricey. - ANS-Semiconductive Laser
A ____________ signal is used is typically transmitted via a fiber optic cable via energizing
and de-energizing the light source. - ANS-PCM
A -three decibel change __________ the output by ___________ percentage -
ANS-decreases, 50
A +three decibel exchange ___________ the output by using ____________ percent -
ANS-will increase, 100
, A detectors responsivity modifications with the ______________ _____________ -
ANS-incident wavelength
A pulse radar depends on the ______________ section for timing - ANS-synchronizer
A truncated parabolic antenna is generally used in a _______ microwave device - ANS-radar
A kind 1 dehydrator makes use of _______________ to do away with liquid and oil -
ANS-refrigerant
A kind of multiplexing this is this is maximum commonly used for fiber optic structures is
____________ - ANS-TDM- Time Division Multiplexing
A waveguide is described as a machine of fabric barriers capable of guiding
_____________________ - ANS-electromagnetic energy
Active ECM is every so often referred to to as ______________ - ANS-jamming
Adding a reflector to a horn antenna will increase ______________ and
_________________. - ANS-strength advantage, directivity
An A-space distinguishes between moving, fixed, objects with _______________________ -
ANS-A-scope the usage of video output of a segment distinguisher
An antennas power benefit is measured in ___________________________ -
ANS-reference to an antenna the use of the identical input
An optical fiber that permits most effective one mild path is - ANS-Single mode
An optical fiber whose middle is manufactured from several concentric layers of cloth is
referred to as ______________________________________ - ANS-multiple graded index
optical fiber
feature impedance is disturbed is sent ________________ and ___________________ of
the line - ANS-capacitors, inductors
CW (non-stop wave) RADARs that use a unmarried antenna and ferrite circulator duplexer
are restrained to low electricity due to _________________________________ - ANS-High
transmitter to receiver leakage
Describe the doppler segment shift of an incoming, outgoing, and desk bound gadgets -
ANS-A-Scoped growth frequency as an item gets closer, decrease because the object
actions away, and no movement has no phase shift
Dry air is utilized in a waveguide to _______________ - ANS-Prevent moisture
Dummy load is a - ANS-resistive load
__________ is the technique employed to fight ECM - ANS-ECCM
__________ is the transmitter feature that makes it tough for a jammer to synchronize with
the radar as a way to use repeater, variety-gate and speed-gate pull off, or fake target
generators - ANS-PRF
_____________ loss is due to high frequency currents flowing near the outer surface of the
conductor - ANS-Skin
______________ is due to the capacitance fashioned between transmission strains -
ANS-Dielectric
_______________ are the most commonly used mild supply for fiber optics - ANS-LED
_______________ are the end result of incorrect waveguide becoming a member of or
obstructions in waveguides - ANS-standing waves
_______________ is due to resistance, in particular in lengthy lines - ANS-Copper loss
_______________ is because of the expanding and collapsing magnetic fields inducing
voltage and modern surfaces near the transmission strains - ANS-Induction loss
_______________ transmission line allows the least velocity (60% of the rate of light) -
ANS-Twisted Pair
_________________ transmission line lets in the greatest RF velocity (ninety seven% of the
velocity of mild) - ANS-open 2-twine
_________________ makes use of the outer conductor to protect the center conductor. -
ANS-Coaxial
_____________________ can offer a effective condensed beam within a slender spectral
range, but are pricey. - ANS-Semiconductive Laser
A ____________ signal is used is typically transmitted via a fiber optic cable via energizing
and de-energizing the light source. - ANS-PCM
A -three decibel change __________ the output by ___________ percentage -
ANS-decreases, 50
A +three decibel exchange ___________ the output by using ____________ percent -
ANS-will increase, 100
, A detectors responsivity modifications with the ______________ _____________ -
ANS-incident wavelength
A pulse radar depends on the ______________ section for timing - ANS-synchronizer
A truncated parabolic antenna is generally used in a _______ microwave device - ANS-radar
A kind 1 dehydrator makes use of _______________ to do away with liquid and oil -
ANS-refrigerant
A kind of multiplexing this is this is maximum commonly used for fiber optic structures is
____________ - ANS-TDM- Time Division Multiplexing
A waveguide is described as a machine of fabric barriers capable of guiding
_____________________ - ANS-electromagnetic energy
Active ECM is every so often referred to to as ______________ - ANS-jamming
Adding a reflector to a horn antenna will increase ______________ and
_________________. - ANS-strength advantage, directivity
An A-space distinguishes between moving, fixed, objects with _______________________ -
ANS-A-scope the usage of video output of a segment distinguisher
An antennas power benefit is measured in ___________________________ -
ANS-reference to an antenna the use of the identical input
An optical fiber that permits most effective one mild path is - ANS-Single mode
An optical fiber whose middle is manufactured from several concentric layers of cloth is
referred to as ______________________________________ - ANS-multiple graded index
optical fiber
feature impedance is disturbed is sent ________________ and ___________________ of
the line - ANS-capacitors, inductors
CW (non-stop wave) RADARs that use a unmarried antenna and ferrite circulator duplexer
are restrained to low electricity due to _________________________________ - ANS-High
transmitter to receiver leakage
Describe the doppler segment shift of an incoming, outgoing, and desk bound gadgets -
ANS-A-Scoped growth frequency as an item gets closer, decrease because the object
actions away, and no movement has no phase shift
Dry air is utilized in a waveguide to _______________ - ANS-Prevent moisture
Dummy load is a - ANS-resistive load
