CIT 345 FINAL EXAM LATEST 2025/2026 ACTUAL EXAM WITH
COMPLETE QUESTIONS AND CORRECT DETAILED ANSWERS (100%
VERIFIED ANSWERS) |ALREADY GRADED A+| ||PROFESSOR
VERIFIED|| ||BRANDNEW!!!||
Which type of access points normally use centralized data
forwarding? - ANSWER-B. Controller-based AP
What capabilities can be found on a WLAN controller? (Choose
all that apply.) - ANSWER-A. VRRP B. Captive portal D. RBAC E.
Wireless intrusion detection system
Which protocols are used to transport 802.11 frames between a
controller-based AP and a WLAN controller? (Choose all that
apply.) - ANSWER-A. GRE C. Mobile IP E. Proprietary IP
tunneling protocols
Which of these WLAN architectures may require the use of a
WNMS server to manage and monitor the WLAN? - ANSWER-D.
All of the above
,2|Page
What are some of the common capabilities of a WLAN controller
architecture? - ANSWER-F. All of the above
Which logical plane of network operation is typically defined by
protocols and intelligence? - ANSWER-D. Control plane
Which option best describes a device used to provide wireless
connectivity for a small number of wired clients? - ANSWER-B.
Wireless workgroup bridge
What are the two main components of a centralized WLAN
architecture? (Choose all that apply.) - ANSWER-A. WLAN
controller E. Controller-based AP
What planes of operation reside in the access points of a
distributed WLAN architecture? (Choose all that apply.) -
ANSWER-B. Data plane C. Network plane
A network administrator is having a hard time getting two WLAN
bridges to associate with one another in a PtP link. The bridge in
,3|Page
building A is on the 172.16.1.0/24 network, and the bridge in
building B resides on the 172.16.2.0/24 network. What is the most
likely cause? - ANSWER-B. The bridges are both configured as
nonroot.
Billy must connect building A via a WLAN bridge link to building C,
which is 30 miles away. He cannot make a direct connection of
that distance because of regulatory power restrictions in his
country. Building B sits between the two remote buildings. What is
the best way for Billy to link the two buildings together using
WLAN bridges? - ANSWER-D. Place a root bridge on building A
with a highly directional antenna, and a nonroot bridge on building
B with a highly directional antenna. Set up another root bridge on
building B with a highly directional antenna, and a nonroot bridge
on building C with a highly directional antenna. Connect the two
bridges on building B via a switch or router.
Which WLAN architectural models typically require support for
802.1Q tagging at the edge on the network when multiple user
VLANs are required? (Choose all that apply.) - ANSWER-A.
Autonomous WLAN architecture C. Distributed WLAN
architecture
, 4|Page
What term best describes a WLAN centralized architecture where
the integration service (IS) and distribution system services (DSS)
are handled by a WLAN controller while generation of certain
802.11 management and control frames are handled by a
controller-based AP? - ANSWER-E. Split MAC
Where is redundancy needed if user traffic is being tunneled in a
centralized WLAN architecture? - ANSWER-B. Redundant
controllers
What would be needed for multiple basic service sets (BSSs) to
exist within the same coverage area of a single access point and
in which all the client stations would be segmented in separate
layer 2 and 3 domains but all communicate within a single layer 1
RF domain? (Choose all that apply.) - ANSWER-A. Virtual
BSSIDs B. SSIDs C. VLANs
What are some of the parameters of a WLAN profile that can be
configured on a WLAN controller? (Choose all that apply.) -
ANSWER-A. SSID C. VLAN D. WMM E. WPA-2