100% satisfaction guarantee Immediately available after payment Both online and in PDF No strings attached 4.6 TrustPilot
logo-home
Exam (elaborations)

Ohio stationary steam engineer Exam | All Questions and Correct Answers | Graded A+ | Verified Answers | Just Released

Rating
-
Sold
1
Pages
38
Grade
A+
Uploaded on
25-08-2025
Written in
2025/2026

Ohio stationary steam engineer Exam | All Questions and Correct Answers | Graded A+ | Verified Answers | Just Released

Institution
Ohio Stationary Steam Engineer
Course
Ohio stationary steam engineer











Whoops! We can’t load your doc right now. Try again or contact support.

Written for

Institution
Ohio stationary steam engineer
Course
Ohio stationary steam engineer

Document information

Uploaded on
August 25, 2025
Number of pages
38
Written in
2025/2026
Type
Exam (elaborations)
Contains
Questions & answers

Subjects

Content preview

Ohio stationary steam engineer Exam | All Questions
and Correct Answers | Graded A+ | Verified Answers |
Just Released
Combustion efficiency may be increased by_____ the primary air -
(ANSWER)Preheating



What is the purpose of cinder reinjection? - (ANSWER)increase efficiency



2 forces of equal intensity acting in opposite directions is? - (ANSWER)tension



What is true about the dew poimt of flue gasses - (ANSWER)dew point is the
temp at which the gasses will condense



What will not cause high stack temps? - (ANSWER)plugged dry pipe



What is true about smoke - (ANSWER)smoke consists of unburned hydrocarbons



WHat is used to reduce SO2 emissions in coal fired boilers? - (ANSWER)Wet or
dry scrubbers



In a solid fuel fired boiler, a gradual increase in flue gas exit temps over a course
of a shift inidicates the boiler operator needs to _______ - (ANSWER)operate
soot blowers

,What watertube bolier is the largest in size and steam-generating compacitity -
(ANSWER)Utility watertube boiler



the blowdown on a safety valve can be altered by changing the setting of the
_____ - (ANSWER)huddling ring



Copper and brass piping may be used for piping systems as long as the temp does
not exceed - (ANSWER)406 degrees



What is not measured in a 3 element feedwater system

-feedwater flow

-drum pressure

-steam flow

-drum level - (ANSWER)drum pressure



If the flame in a gas-fired bolier is pulsating how can the problem be fixed? -
(ANSWER)increase furnace draft



Grindability of coal is an issue to be considered when operating which kid of coal-
burining equipment? - (ANSWER)ball-and-race pulvarizer



When using an induced draft fan, where will the strongest negative draft be found
- (ANSWER)at the inlet of the ID fan

,How do you bank a fuel oil-fired boiler? - (ANSWER)turn off the fuel and air
supplies, the re-light the burner as necessary to maintain a predetermined
minimum steam pressure



What is true about the lube oil used in a steam turbine - (ANSWER)it must readily
seperate oil and water



What supplies the oil to a large steam turbine during start-up - (ANSWER)aux oil
pump



What device prevents the over-travel of the governor linkage that might be
caused by the weight of the governor components - (ANSWER)Dashpot



When taking a boiler out of service what should you not do - (ANSWER)close the
vent



what type of turbine oil purification system periodically removes a potion of the
oil and replaces it with fresh oil? - (ANSWER)makeup oil system



what type of steam turbine system has steam take-offs prior to going into the
condenser? - (ANSWER)extraction turbine



What is the pressure above which the exhaust side of a steam turbine and the
connected piping may be protected by either a safety valve or a rupture disc, or a
combination of the 2 - (ANSWER)15 psi

, What grade fuel oil may be ignited by an electric spark from electrodes powered
by an ignition transformer? - (ANSWER)#2



what is the cheapest, easiest form of water treatment? - (ANSWER)heating the
water



A turbine exhausts steam @ 15 psi. This steam is used in a low-pressure
application such as a deareator. this type of turbine is called a: - (ANSWER)back-
pressure turbine



At what temp should you add cooling water to a turbines bearings? -
(ANSWER)110-120 degrees



What is produced from the reaction between sodium sulfite and oxygen? -
(ANSWER)sodium sulfate



What is the purpose of an attemperator - (ANSWER)reduce temp of superheated
steam by adding a water mist



What are the 2 main methods by which steam is prevented from leaking out
around the turbine shaft where the shaft exits the casing? - (ANSWER)labyrinth
seals and carbon rings

Get to know the seller

Seller avatar
Reputation scores are based on the amount of documents a seller has sold for a fee and the reviews they have received for those documents. There are three levels: Bronze, Silver and Gold. The better the reputation, the more your can rely on the quality of the sellers work.
Examinor Teachme2-tutor
View profile
Follow You need to be logged in order to follow users or courses
Sold
2950
Member since
1 year
Number of followers
1
Documents
3334
Last sold
19 hours ago

5.0

2 reviews

5
2
4
0
3
0
2
0
1
0

Recently viewed by you

Why students choose Stuvia

Created by fellow students, verified by reviews

Quality you can trust: written by students who passed their tests and reviewed by others who've used these notes.

Didn't get what you expected? Choose another document

No worries! You can instantly pick a different document that better fits what you're looking for.

Pay as you like, start learning right away

No subscription, no commitments. Pay the way you're used to via credit card and download your PDF document instantly.

Student with book image

“Bought, downloaded, and aced it. It really can be that simple.”

Alisha Student

Frequently asked questions