MSSC Manufacturing Processes and Production EXAM 2025/2026
ACTUAL COMPLETE REAL EXAM QUESTIONS AND ALL CORRECT
ANSWERS (VERIFIED ANSWERS) GUARANTEED SUCCESS / 2025
BRAND NEW EXAM!!
What is used most often to cut raw stock into shorter
lengths? - ANSWER-
horizontal band
saw
When using a horizontal band sat to cut stock to a specific
length, the saw blade should touch ______. - ANSWER-just the
outside of the line you created on the material
On a vertical band saw, the blade guide should be set ______. -
ANSWER-3/8
inches to 1/2 inches above the stock at its
thickest point
A ______ punch is used to create a very small indentation. -
ANSWER-prick
,Layout work is the operation of ______. - ANSWER-
transferring data from a
technical drawing to
the part
A drill press will under-size the holes if the ______. -
ANSWER-drill bit has a
worn
margin
During the tapping operation, the tap should be rotated counter
clockwise for 1/2 turn following each 1 turn clockwise to
______. - ANSWER-break off the chips to avoid jamming the tap
The maximum strength is reached when the thread
engagement reaches
______. - ANSWER-60
percent
Proper ______ require(s) that when parts are requisitioned that
they are easy to
locate and can be delivered to another department on time. -
ANSWER-material
handling
, The ______ on a boiler burner makes is easy to detect a
main flame. -
ANSWER-UV fire
eye
A thorough check for a history of similar problems should
occur ______. -
ANSWER-on problems that keep recurring at
regular intervals
An announcement system called ______ (Japanese for
signboard) is used to
announce the need for reactive maintenance. -
ANSWER-andon
Companies use ______ to show data about the progress of
production. -
ANSWER-job status
reports
Manufacturing paths are indicated by ______ documents. -
ANSWER-process
flow
ACTUAL COMPLETE REAL EXAM QUESTIONS AND ALL CORRECT
ANSWERS (VERIFIED ANSWERS) GUARANTEED SUCCESS / 2025
BRAND NEW EXAM!!
What is used most often to cut raw stock into shorter
lengths? - ANSWER-
horizontal band
saw
When using a horizontal band sat to cut stock to a specific
length, the saw blade should touch ______. - ANSWER-just the
outside of the line you created on the material
On a vertical band saw, the blade guide should be set ______. -
ANSWER-3/8
inches to 1/2 inches above the stock at its
thickest point
A ______ punch is used to create a very small indentation. -
ANSWER-prick
,Layout work is the operation of ______. - ANSWER-
transferring data from a
technical drawing to
the part
A drill press will under-size the holes if the ______. -
ANSWER-drill bit has a
worn
margin
During the tapping operation, the tap should be rotated counter
clockwise for 1/2 turn following each 1 turn clockwise to
______. - ANSWER-break off the chips to avoid jamming the tap
The maximum strength is reached when the thread
engagement reaches
______. - ANSWER-60
percent
Proper ______ require(s) that when parts are requisitioned that
they are easy to
locate and can be delivered to another department on time. -
ANSWER-material
handling
, The ______ on a boiler burner makes is easy to detect a
main flame. -
ANSWER-UV fire
eye
A thorough check for a history of similar problems should
occur ______. -
ANSWER-on problems that keep recurring at
regular intervals
An announcement system called ______ (Japanese for
signboard) is used to
announce the need for reactive maintenance. -
ANSWER-andon
Companies use ______ to show data about the progress of
production. -
ANSWER-job status
reports
Manufacturing paths are indicated by ______ documents. -
ANSWER-process
flow
