IAAI CFI EXAM TESTBANK AND STUDY
QUESTIONS AND ANSWERS
A liquid with a flash point ABOVE 100F - ANS Combustible Liquid
If the current flowing out from an electrical panel is 12.5 amps, and it then flows through an
electrical load of 1500 watts, what is the amperage of the remaining current flow of the return
circuit? - ANS 12.5
If a hair dryer draws 8.3amps (in a home with 120-volt service), what is the wattage?
*Power (P) = current (I) x voltage (V)
Watts = amps x volts - ANS 1000
The year of the first edition of NFPA 1033 - ANS 1987
Copyright ©2025 BRIGHTSTARS ALL RIGHTS RESERVED 1
,The recommended distance for securing the perimeter of a blast scene
*That is, the distance from the furthest debris - ANS 1.5 times
What temperature in the upper gas layer causes the onset of Flashover? - ANS 1100°F
The temperature at which copper melts - ANS 1960°F
The measurement of the radiant heat flux (from gas layer to the floor) that indicates the onset
of flashover - ANS 2 W/cm2
The voltage between the two hot wires at the service entrance cables in most single-family
residences in the United States (single-phase service with three wires) - ANS 240 volts
The revision cycle for NFPA 921 (timespan) - ANS 3 years
Copyright ©2025 BRIGHTSTARS ALL RIGHTS RESERVED 2
,The flash point of power steering fluid - ANS 350°F
In high-pressure fuel-injected vehicles, this is the typical range of pressure that is used to pump
fuel from a fuel tank - ANS 35-70 p.s.i.
The lower explosive and upper explosive limit of natural gas (methane)? - ANS 5 and 17
The ignition temperature of power steering fluid - ANS 680°F
Any substance that can undergo combustion - ANS Fuel
Two factors or situations leading to a fire that may show the nature of the incident
responsibility. - ANS Act or Omission
This concept should not be included in a summary report of findings. - ANS Additional
Investigative Recommendations
A law that may govern the fire investigation of a boat - ANS Admiralty Law
Copyright ©2025 BRIGHTSTARS ALL RIGHTS RESERVED 3
, A type of device in a vehicle, which can cause an electrical overload to factory installed wiring -
ANS After-market Equipment
Evidence of smoke or soot in the lungs, bronchi, and trachea is one of the most significant
factors in confirming that, at the time of the fire, the victim was WHAT? - ANS Alive and
Breathing
Those who have the responsibility for monitoring safety conditions at the fire or explosion
scene - ANS All Team Members
The melting temperature of aluminum - ANS 1220°F
Which one of these is NOT considered a competent ignition source?
Metal-to-metal sparks,
Aluminum-to-pavement sparks,
Metal-to-pavement sparks,
Motor bearing sparks - ANS Aluminum-to-pavement sparks
Copyright ©2025 BRIGHTSTARS ALL RIGHTS RESERVED 4
QUESTIONS AND ANSWERS
A liquid with a flash point ABOVE 100F - ANS Combustible Liquid
If the current flowing out from an electrical panel is 12.5 amps, and it then flows through an
electrical load of 1500 watts, what is the amperage of the remaining current flow of the return
circuit? - ANS 12.5
If a hair dryer draws 8.3amps (in a home with 120-volt service), what is the wattage?
*Power (P) = current (I) x voltage (V)
Watts = amps x volts - ANS 1000
The year of the first edition of NFPA 1033 - ANS 1987
Copyright ©2025 BRIGHTSTARS ALL RIGHTS RESERVED 1
,The recommended distance for securing the perimeter of a blast scene
*That is, the distance from the furthest debris - ANS 1.5 times
What temperature in the upper gas layer causes the onset of Flashover? - ANS 1100°F
The temperature at which copper melts - ANS 1960°F
The measurement of the radiant heat flux (from gas layer to the floor) that indicates the onset
of flashover - ANS 2 W/cm2
The voltage between the two hot wires at the service entrance cables in most single-family
residences in the United States (single-phase service with three wires) - ANS 240 volts
The revision cycle for NFPA 921 (timespan) - ANS 3 years
Copyright ©2025 BRIGHTSTARS ALL RIGHTS RESERVED 2
,The flash point of power steering fluid - ANS 350°F
In high-pressure fuel-injected vehicles, this is the typical range of pressure that is used to pump
fuel from a fuel tank - ANS 35-70 p.s.i.
The lower explosive and upper explosive limit of natural gas (methane)? - ANS 5 and 17
The ignition temperature of power steering fluid - ANS 680°F
Any substance that can undergo combustion - ANS Fuel
Two factors or situations leading to a fire that may show the nature of the incident
responsibility. - ANS Act or Omission
This concept should not be included in a summary report of findings. - ANS Additional
Investigative Recommendations
A law that may govern the fire investigation of a boat - ANS Admiralty Law
Copyright ©2025 BRIGHTSTARS ALL RIGHTS RESERVED 3
, A type of device in a vehicle, which can cause an electrical overload to factory installed wiring -
ANS After-market Equipment
Evidence of smoke or soot in the lungs, bronchi, and trachea is one of the most significant
factors in confirming that, at the time of the fire, the victim was WHAT? - ANS Alive and
Breathing
Those who have the responsibility for monitoring safety conditions at the fire or explosion
scene - ANS All Team Members
The melting temperature of aluminum - ANS 1220°F
Which one of these is NOT considered a competent ignition source?
Metal-to-metal sparks,
Aluminum-to-pavement sparks,
Metal-to-pavement sparks,
Motor bearing sparks - ANS Aluminum-to-pavement sparks
Copyright ©2025 BRIGHTSTARS ALL RIGHTS RESERVED 4
