1|Page
IICL CONTAINER INSPECTOR FINAL EXAM NEWEST
ACTUAL EXAM COMPLETE 150 QUESTIONS AND
CORRECT DETAILED ANSWERS WITH RATIONALES
(VERIFIED ANSWERS) |ALREADY GRADED A+/
LATEST EXAM!!!
Which of the following defects requires repair?
A. A loose door gasket
B. A bent J-bar that does not affect door operation
C. A dent 13mm (1/2 in) deep on the door sill
D. Four dents, each 11mm (7/16 in) deep, on contiguous
outboard corrugations of a roof panel - Answer-A. A loose
door gasket
Of the following conditions in a dry-van container, which
one would require cleaning?
A. Raised mud foot prints in excess of what might
normally remain after a sweep out
B. Dry dust covering dried floor stains as might normally
be found after a sweep out
C. Coffee beans remaining inside the container as might
occur after a sweep out
,2|Page
D. Polyurethane beads as might be expected to lodge in
grooves between floorboards after a sweep out - Answer-
C. Coffee beans remaining inside the container as might
occur after a sweep out
An Equipment Interchange Receipt (EIR), based on an
inspection with no damage found, can be evidence of a
container's compliance with: A. Australian Timber
Component Treatment Regulations B. Convention for Safe
Containers (CSC) regulations through the ACEP Program
C. Transport under custom's seal (TIR) regulations D.
International Standards Organization (ISO) CEDEX codes
regulations - Answer-B. Convention for Safe Containers
(CSC) regulations through the ACEP Program
The top of a replacement plastic ventilator should be
centered what distance from the top side rail? A. 50-55mm
(2-2 3/16 in) B. 70-75mm (2 5/8 - 3 in)
C. 100mm (4in) D. 150mm (6 in) - Answer-A. 50-55mm (2-
2 3/16 in)
When must a reference line extend the full length of a
bottom side rail? A. When there are two or more areas of
,3|Page
damage on the bottom side rail B. When there is a sharp
bend in the bottom side rail
C. When there is a bowing over the entire bottom side rail
D. When there is additional damage to the bottom side rail
so that the reference line cannot be positioned over the
ends of the damage - Answer-C. When there is a bowing
over the entire bottom side rail
Which of the following is NOT a transverse structural
member of the container?
A. Front sill B. Tunnel rail
C. Rear header
D. Crossmember - Answer-B. Tunnel rail
A steel corner fitting is being replaced. To ensure better
weld penetration, IICL recommends that the edges of parts
adjacent to the corner fitting be ground to a minimum
bevel of? A. 30 degrees B. 45 degrees
C. 55 degrees D. 60 degrees - Answer-B. 45 degrees
Which of the following components is sometimes placed
longitudinally in the container to support plywood flooring?
A. Transverse bow B. Gusset
, 4|Page
C. Hat section center spacer
D. Threshold plate - Answer-C. Hat section center spacer
Assuming owner and environmental regulations permit,
which of the following procedures is NOT recommended
for repairing tarpaulins or open top containers? A.
Cleaning the area to be covered with acetone or mineral
spirit B. Using a heat gun to fuse a patch to the tarpaulin
C. Sewing on a patch of the same material as the tarpaulin
D. Repairing a 6 mm (1/4 in ) pin hole with an epoxy
compound - Answer-C. Sewing on a patch of the same
material as the tarpaulin
Which of the following is an example of a plank floor
condition requiring repair AND which should be considered
as damage?
A. A crack or split with no evidence of impact, which leaks
light
B. A crack or split with a sign of impact which does not
leak light
C. A crack or split, adjacent to a dented bottom rail, which
leaks light
IICL CONTAINER INSPECTOR FINAL EXAM NEWEST
ACTUAL EXAM COMPLETE 150 QUESTIONS AND
CORRECT DETAILED ANSWERS WITH RATIONALES
(VERIFIED ANSWERS) |ALREADY GRADED A+/
LATEST EXAM!!!
Which of the following defects requires repair?
A. A loose door gasket
B. A bent J-bar that does not affect door operation
C. A dent 13mm (1/2 in) deep on the door sill
D. Four dents, each 11mm (7/16 in) deep, on contiguous
outboard corrugations of a roof panel - Answer-A. A loose
door gasket
Of the following conditions in a dry-van container, which
one would require cleaning?
A. Raised mud foot prints in excess of what might
normally remain after a sweep out
B. Dry dust covering dried floor stains as might normally
be found after a sweep out
C. Coffee beans remaining inside the container as might
occur after a sweep out
,2|Page
D. Polyurethane beads as might be expected to lodge in
grooves between floorboards after a sweep out - Answer-
C. Coffee beans remaining inside the container as might
occur after a sweep out
An Equipment Interchange Receipt (EIR), based on an
inspection with no damage found, can be evidence of a
container's compliance with: A. Australian Timber
Component Treatment Regulations B. Convention for Safe
Containers (CSC) regulations through the ACEP Program
C. Transport under custom's seal (TIR) regulations D.
International Standards Organization (ISO) CEDEX codes
regulations - Answer-B. Convention for Safe Containers
(CSC) regulations through the ACEP Program
The top of a replacement plastic ventilator should be
centered what distance from the top side rail? A. 50-55mm
(2-2 3/16 in) B. 70-75mm (2 5/8 - 3 in)
C. 100mm (4in) D. 150mm (6 in) - Answer-A. 50-55mm (2-
2 3/16 in)
When must a reference line extend the full length of a
bottom side rail? A. When there are two or more areas of
,3|Page
damage on the bottom side rail B. When there is a sharp
bend in the bottom side rail
C. When there is a bowing over the entire bottom side rail
D. When there is additional damage to the bottom side rail
so that the reference line cannot be positioned over the
ends of the damage - Answer-C. When there is a bowing
over the entire bottom side rail
Which of the following is NOT a transverse structural
member of the container?
A. Front sill B. Tunnel rail
C. Rear header
D. Crossmember - Answer-B. Tunnel rail
A steel corner fitting is being replaced. To ensure better
weld penetration, IICL recommends that the edges of parts
adjacent to the corner fitting be ground to a minimum
bevel of? A. 30 degrees B. 45 degrees
C. 55 degrees D. 60 degrees - Answer-B. 45 degrees
Which of the following components is sometimes placed
longitudinally in the container to support plywood flooring?
A. Transverse bow B. Gusset
, 4|Page
C. Hat section center spacer
D. Threshold plate - Answer-C. Hat section center spacer
Assuming owner and environmental regulations permit,
which of the following procedures is NOT recommended
for repairing tarpaulins or open top containers? A.
Cleaning the area to be covered with acetone or mineral
spirit B. Using a heat gun to fuse a patch to the tarpaulin
C. Sewing on a patch of the same material as the tarpaulin
D. Repairing a 6 mm (1/4 in ) pin hole with an epoxy
compound - Answer-C. Sewing on a patch of the same
material as the tarpaulin
Which of the following is an example of a plank floor
condition requiring repair AND which should be considered
as damage?
A. A crack or split with no evidence of impact, which leaks
light
B. A crack or split with a sign of impact which does not
leak light
C. A crack or split, adjacent to a dented bottom rail, which
leaks light
