CFT MONITOR CERTIFICATION EXAM 2025/2026 QUESTIONS WITH VERIFIED CORRECT SOLUTIONS || 100% GUARANTEED PASS <BRAND NEW VERSION>

CFT MONITOR CERTIFICATION EXAM 2025/2026 QUESTIONS WITH VERIFIED CORRECT SOLUTIONS || 100% GUARANTEED PASS &lt;BRAND NEW VERSION&gt; 1. CFT Equipment - ANSWER calibrated scale, markers, ammo cans, measuring tape and/or wheel, stopwatch, engineer tape or chalk, dummy grenades 2. MANUF requirements - ANSWER - At least 107 yds long - indoor/outdoor, turf field - 3 monitors 3. MANUF Monitor tasks and roles - ANSWER - Observe marines for correct performance - call out time passed (in intervals) - report results 4. monitors posted at start and mid point of 880 run - ensure marines stay on course 5. Roles: observe safety and proper execution 6. Ammo can Equipment - ANSWER 5.56mm ammo cans: - 30 pounds 7. -contents should not move excessively - grip tape on the sides - calibrated scale - time piece accurate to the second 8. MANUF Injuries - ANSWER lower back joint twists or sprains 9. MANUF equipment - ANSWER ammo cans stop watch engineer tape or chalk dummy grenades visible markers 10. The CFT was designed to evaluate which of the following? - ANSWER Answer: Stamina, Agility, Strength 11. Which equipment is required for a CFT? - ANSWER Calibrated scale, dummy grenades, and measuring tape 12. As a CFT monitor, you must assist in the risk management(RM) process for the CFT. Which of the following describes the RM process steps? - ANSWER Identifying hazards, assessing risks, determining which risks are most important, implementing controls, and supervising the participants 13. The CFT monitor is responsible for setting up the events, scoring accurately, using proper equipment, and __________ - ANSWER ensuring participants wear the proper uniform 14. Which of the following are tasks performed by the CFT monitor during an actual CFT? - ANSWER Ensuring proper technique, calling out repetitions. 15. Location choices for the movement to contact event include outdoor or indoor venue. What are the minimum location requirements you will need to meet? - ANSWER Reasonable level, few to no obstacles 16. During the maneuver to contact event when may Marines remove uniform blouses? - ANSWER With the commander's authorization 17. As a CFT monitor, you have setup the movement to contact event on an out-and-back route. The start and finish lines are the same. What is the minimum number of monitors required for this route? - ANSWER 3 18. The participant's goal during the movement to contact event is to _______ - ANSWER finish as quickly as possible 19. SSgt Winifred Carter a 28-year-old female, ran the movement to contact event in 3:18. What is her score for the movement to contact event? - ANSWER 95 20. What are the equipment requirements for ammunition cans used in the ammunition lift event? - ANSWER The contents should not move excessively when lifted, grip tape applied to the can sides, and use M2A1 5.56mm cans only. 21. Which of the following are common injuries associated with the ammunition lift event? - ANSWER Chipped teeth, black eyes, and broken noses. 22. Which location would be best suited for the ammunition lift event of the CFT? - ANSWER Open, flat, outdoor area