Page |1
MARYLAND STATE INSPECTION-TECHNICAL
EXAM 2025| BRAND NEW ACTUAL EXAM WITH
100% VERIFIED QUESTIONS AND CORRECT
SOLUTIONS| GUARANTEED VALUE PACK| ACE
YOUR GRADES.
Steering wheel - correct answer - reject for
cracks and breaks
non continuity
not original or equivalent size
objects mounted on column
Inspection for lash - correct answer - front wheels straight ahead
turn wheel until motion can be observed at road wheels
engine must be running for vehicles with power steering
Failure for lash - correct answer - 16 inch wheel 2 inches
18 inch wheel 2 1/4 inches
20 inch wheel 2 1/2 inches
22 inch wheel 2 3/4 inches
, Page |2
lash failure for power steering system - correct answer - 0.4 inches or
10mm
inspect for travel - correct answer - turn steering full right and full left
jack front wheels slightly on vehicles without power steering.
check for binding and jamming
inspect for linkage play - correct answer - lift front end with wheels straight
ahead, apply brakes,grasp front and rear of tire ,record movement at
extreme front or rear of tire
Camber - correct answer - inward or outward tilt of the top of the wheel
from vertical
Ball joint wear-without wear indicators - correct answer - reject for
movement exceeding manufacturer specs
repaired by heating
equipped with tightener or repair kit
Types of ball joints - correct answer - wear indicator
standard
turning torque
MARYLAND STATE INSPECTION-TECHNICAL
EXAM 2025| BRAND NEW ACTUAL EXAM WITH
100% VERIFIED QUESTIONS AND CORRECT
SOLUTIONS| GUARANTEED VALUE PACK| ACE
YOUR GRADES.
Steering wheel - correct answer - reject for
cracks and breaks
non continuity
not original or equivalent size
objects mounted on column
Inspection for lash - correct answer - front wheels straight ahead
turn wheel until motion can be observed at road wheels
engine must be running for vehicles with power steering
Failure for lash - correct answer - 16 inch wheel 2 inches
18 inch wheel 2 1/4 inches
20 inch wheel 2 1/2 inches
22 inch wheel 2 3/4 inches
, Page |2
lash failure for power steering system - correct answer - 0.4 inches or
10mm
inspect for travel - correct answer - turn steering full right and full left
jack front wheels slightly on vehicles without power steering.
check for binding and jamming
inspect for linkage play - correct answer - lift front end with wheels straight
ahead, apply brakes,grasp front and rear of tire ,record movement at
extreme front or rear of tire
Camber - correct answer - inward or outward tilt of the top of the wheel
from vertical
Ball joint wear-without wear indicators - correct answer - reject for
movement exceeding manufacturer specs
repaired by heating
equipped with tightener or repair kit
Types of ball joints - correct answer - wear indicator
standard
turning torque
