12.5 - ANSWER If the current flowing out from an electrical panel is 12.5 amps, and it then
flows through an electrical load of 1500 watts, what is the amperage of the remaining current
flow of the return circuit?
1000 - ANSWER If a hair dryer draws 8.3amps (in a home with 120-volt service), what is the
wattage?
*Power (P) = current (I) x voltage (V)
Watts = amps x volts
1987 - ANSWER The year of the first edition of NFPA 1033
1.5 times - ANSWER The recommended distance for securing the perimeter of a blast scene
*That is, the distance from the furthest debris
1100°F - ANSWER What temperature in the upper gas layer causes the onset of Flashover?
1960°F - ANSWER The temperature at which copper melts
2 W/cm2 - ANSWER The measurement of the radiant heat flux (from gas layer to the floor)
that indicates the onset of flashover
240 volts - ANSWER The voltage between the two hot wires at the service entrance cables in
most single-family residences in the United States (single-phase service with three wires)
3 years - ANSWER The revision cycle for NFPA 921 (timespan)
350°F - ANSWER The flash point of power steering fluid
35-70 p.s.i. - ANSWER In high-pressure fuel-injected vehicles, this is the typical range of
,pressure that is used to pump fuel from a fuel tank
5 and 17 - ANSWER The lower explosive and upper explosive limit of natural gas (methane)?
680°F - ANSWER The ignition temperature of power steering fluid
Fuel - ANSWER Any substance that can undergo combustion
Act or Omission - ANSWER Two factors or situations leading to a fire that may show the
, nature Nof Nthe Nincident Nresponsibility.
Additional NInvestigative NRecommendations N- NANSWER This Nconcept Nshould Nnot Nbe
Nincluded Nin Na Nsummary Nreport Nof Nfindings.
Admiralty NLaw N- NANSWER A Nlaw Nthat Nmay Ngovern Nthe Nfire Ninvestigation Nof Na Nboat
After-market NEquipment N- NANSWER A Ntype Nof Ndevice Nin Na Nvehicle, Nwhich Ncan Ncause
Nan Nelectrical Noverload Nto Nfactory Ninstalled Nwiring
Alive Nand NBreathing N- NANSWER N N Evidence Nof Nsmoke Nor Nsoot Nin Nthe Nlungs, Nbronchi, Nand
Ntrachea Nis None Nof Nthe Nmost Nsignificant Nfactors Nin Nconfirming Nthat, Nat Nthe Ntime Nof Nthe Nfire,
Nthe Nvictim Nwas NWHAT?
All NTeam NMembers N- NANSWER Those Nwho Nhave Nthe Nresponsibility Nfor Nmonitoring
Nsafety Nconditions Nat Nthe Nfire Nor Nexplosion Nscene
1220°F N- NANSWER The Nmelting Ntemperature Nof Naluminum
Aluminum-to-pavement Nsparks N- NANSWER Which None Nof Nthese Nis NNOT Nconsidered
Na Ncompetent Nignition Nsource?
Metal-to-metal Nsparks,
Aluminum-to-pavement
N
sparks, NMetal-to-pavement
N
sparks, NMotor Nbearing Nsparks
N
Heat NRelease NRate N- NANSWER A Nmeaningful Nanalysis Nof Na Nfire Nrequires Nan Nunderstanding
Nof Nthe Nfire Ngrowth, Nthe Ntotal Nheat Nreleased, Nand NWHAT?
Arc-fault Ncircuit Ninterrupter N- NANSWER What Ndoes Nhe Nterm NAFCI Nstand Nfor? NAnd, Nthe
N"A" Nspecifically Nrepresents Nwhat?
ASTM N- NANSWER The Norganization Nthat Ndevelops Nstandard Nmethods Nfor Ntesting
materials NAuto-ignition N- NANSWER
N Initiation Nof Ncombustion Nby Nheat Nbut Nwithout Na
spark Nor Nflame
N
Backdraft N- NANSWER A Ndeflagration Nresulting Nfrom Nthe Nsudden Nintroduction Nof Nair
Ninto Na Nconfined Nspace Ncontaining Noxygen-deficient Nproducts Nof Nincomplete
Ncombustion
Backdraft N- NANSWER An Nexplosion Ncaused Nby Na Ncombination Nof Ncombustible Nmaterials Nheated