Exam Set Questions And Verified
Answers (solutions) | Get It 100%
Accurate!!| Already Passed A+
Combustible Liquid - ✔✔ANSWER✔✔>>A liquid with a flash point ABOVE 100F
12.5 - ✔✔ANSWER✔✔>>If the current flowing out from an electrical panel is 12.5
amps, and it then flows through an electrical load of 1500 watts, what is the amperage
of the remaining current flow of the return circuit?
1000 - ✔✔ANSWER✔✔>>If a hair dryer draws 8.3amps (in a home with 120-volt
service), what is the wattage?
*Power (P) = current (I) x voltage (V)
Watts = amps x volts
1987 - ✔✔ANSWER✔✔>>The year of the first edition of NFPA 1033
1.5 times - ✔✔ANSWER✔✔>>The recommended distance for securing the perimeter of
a blast scene
*That is, the distance from the furthest debris
1100°F - ✔✔ANSWER✔✔>>What temperature in the upper gas layer causes the onset
of Flashover?
1960°F - ✔✔ANSWER✔✔>>The temperature at which copper melts
2 W/cm2 - ✔✔ANSWER✔✔>>The measurement of the radiant heat flux (from gas layer
to the floor) that indicates the onset of flashover
240 volts - ✔✔ANSWER✔✔>>The voltage between the two hot wires at the service
entrance cables in most single-family residences in the United States (single-phase
service with three wires)
,3 years - ✔✔ANSWER✔✔>>The revision cycle for NFPA 921 (timespan)
350°F - ✔✔ANSWER✔✔>>The flash point of power steering fluid
35-70 p.s.i. - ✔✔ANSWER✔✔>>In high-pressure fuel-injected vehicles, this is the
typical range of pressure that is used to pump fuel from a fuel tank
5 and 17 - ✔✔ANSWER✔✔>>The lower explosive and upper explosive limit of natural
gas (methane)?
680°F - ✔✔ANSWER✔✔>>The ignition temperature of power steering fluid
Fuel - ✔✔ANSWER✔✔>>Any substance that can undergo combustion
Act or Omission - ✔✔ANSWER✔✔>>Two factors or situations leading to a fire that may
show the nature of the incident responsibility.
Additional Investigative Recommendations - ✔✔ANSWER✔✔>>This concept should
not be included in a summary report of findings.
Admiralty Law - ✔✔ANSWER✔✔>>A law that may govern the fire investigation of a
boat
After-market Equipment - ✔✔ANSWER✔✔>>A type of device in a vehicle, which can
cause an electrical overload to factory installed wiring
Alive and Breathing - ✔✔ANSWER✔✔>>Evidence of smoke or soot in the lungs,
bronchi, and trachea is one of the most significant factors in confirming that, at the time
of the fire, the victim was WHAT?
All Team Members - ✔✔ANSWER✔✔>>Those who have the responsibility for
monitoring safety conditions at the fire or explosion scene
1220°F - ✔✔ANSWER✔✔>>The melting temperature of aluminum
Aluminum-to-pavement sparks - ✔✔ANSWER✔✔>>Which one of these is NOT
considered a competent ignition source?
Metal-to-metal sparks,
Aluminum-to-pavement sparks,
Metal-to-pavement sparks,
Motor bearing sparks
, Heat Release Rate - ✔✔ANSWER✔✔>>A meaningful analysis of a fire requires an
understanding of the fire growth, the total heat released, and WHAT?
Arc-fault circuit interrupter - ✔✔ANSWER✔✔>>What does he term AFCI stand for?
And, the "A" specifically represents what?
ASTM - ✔✔ANSWER✔✔>>The organization that develops standard methods for
testing materials
Auto-ignition - ✔✔ANSWER✔✔>>Initiation of combustion by heat but without a spark or
flame
Backdraft - ✔✔ANSWER✔✔>>A deflagration resulting from the sudden introduction of
air into a confined space containing oxygen-deficient products of incomplete combustion
Backdraft - ✔✔ANSWER✔✔>>An explosion caused by a combination of combustible
materials heated to the ignition point and a sudden introduction of oxygen to support
combustion
Backfire Flame Arrestor - ✔✔ANSWER✔✔>>A boat device that owners fail to keep
clean, which is a frequent cause of engine compartment fires on boats
Ballast - ✔✔ANSWER✔✔>>A device on a fluorescent light fixture that transforms the
voltage from normal household voltage to a higher voltage
Battery - ✔✔ANSWER✔✔>>The starter motor draws its energy from this source
Beyond a Reasonable Doubt - ✔✔ANSWER✔✔>>The burden of proof in a criminal trial
Bimetallic Thermostats - ✔✔ANSWER✔✔>>The component that controls temperature
in many heat-producing appliances
BLEVE - ✔✔ANSWER✔✔>>This may occur when the vapor pressure of a liquid
exceeds atmospheric pressure
*And this is the most common mechanical explosion
Boiling Point - ✔✔ANSWER✔✔>>The temperature or point at which the vapor pressure
of a liquid equals the external pressure applied
Bonding - ✔✔ANSWER✔✔>>The process of electrically connecting two or more
conductive objects