Home Inspector Exam with 102 Questions &
Complete Answers Latest Updated 100%
Verified Solutions| Newest 2024-2025
Which of the following soils can support the least load-bearing pressure? - ✔✔Silt
with high compressibility
In general, the grading around a building should be positively sloped for how many feet
away from the building? - ✔✔10 feet
Flashing is not required at which of the following locations? - ✔✔Above projecting
masonry
Under which of the following conditions is a two-coat stucco system acceptable on the
exterior of a building? - ✔✔If the system is installed over masonry or concrete
Which of the following locations is the worst place to cut a hole in an I-joist? -
✔✔Near the end of the joist in the web
Why must building footings extend below the frost line? - ✔✔So that the soil around
the footing does not freeze, expand, and cause the footing to shift
Which of the following locations does not require a GFCI outlet? - ✔✔Receptacles
that serve appliances
Which of the following is a way that many homes' electrical systems are grounded? -
✔✔Through a connection to the cold water piping
, What are the types of heat that must be taken into account when calculating the cooling
loads for an HVAC system? - ✔✔Sensible and latent heat
How many BTU's per hour is a ton of cooling capacity in HVAC equipment equal to? -
✔✔12,000 btu per hour
A gas furnace is being installed in a brand new building. What is the most likely reason
that an outdoor air source would be required? - ✔✔The building has unusually tight
construction
What is the purpose of an expansion tank in a hot water system? - ✔✔It allows the
water to expand as it warms without increasing the pressure in the system
Which of the following is not a code requirement for electric clothes dryer exhaust ducts?
- ✔✔The diameter of the duct must be per the manufacturer's requirements but not less
than 6"
The utility bills for heating and cooling a home are much higher than expected. Which of
the following choices is probably not a reason for this increased cost? - ✔✔The fresh
air intake for the HVAC system is incorrectly sized
Which of the following would be most likely to have the highest R-value? - ✔✔6"
fiberglass batt insulation
Which of the following is not a form of home inspection report? - ✔✔Disclaimer
The home inspection report should be delivered to the client: - ✔✔After the report has
been finalized by the home inspector
Complete Answers Latest Updated 100%
Verified Solutions| Newest 2024-2025
Which of the following soils can support the least load-bearing pressure? - ✔✔Silt
with high compressibility
In general, the grading around a building should be positively sloped for how many feet
away from the building? - ✔✔10 feet
Flashing is not required at which of the following locations? - ✔✔Above projecting
masonry
Under which of the following conditions is a two-coat stucco system acceptable on the
exterior of a building? - ✔✔If the system is installed over masonry or concrete
Which of the following locations is the worst place to cut a hole in an I-joist? -
✔✔Near the end of the joist in the web
Why must building footings extend below the frost line? - ✔✔So that the soil around
the footing does not freeze, expand, and cause the footing to shift
Which of the following locations does not require a GFCI outlet? - ✔✔Receptacles
that serve appliances
Which of the following is a way that many homes' electrical systems are grounded? -
✔✔Through a connection to the cold water piping
, What are the types of heat that must be taken into account when calculating the cooling
loads for an HVAC system? - ✔✔Sensible and latent heat
How many BTU's per hour is a ton of cooling capacity in HVAC equipment equal to? -
✔✔12,000 btu per hour
A gas furnace is being installed in a brand new building. What is the most likely reason
that an outdoor air source would be required? - ✔✔The building has unusually tight
construction
What is the purpose of an expansion tank in a hot water system? - ✔✔It allows the
water to expand as it warms without increasing the pressure in the system
Which of the following is not a code requirement for electric clothes dryer exhaust ducts?
- ✔✔The diameter of the duct must be per the manufacturer's requirements but not less
than 6"
The utility bills for heating and cooling a home are much higher than expected. Which of
the following choices is probably not a reason for this increased cost? - ✔✔The fresh
air intake for the HVAC system is incorrectly sized
Which of the following would be most likely to have the highest R-value? - ✔✔6"
fiberglass batt insulation
Which of the following is not a form of home inspection report? - ✔✔Disclaimer
The home inspection report should be delivered to the client: - ✔✔After the report has
been finalized by the home inspector
