Brake test
Turning the brake drums - ANSuse damping strap to reduce chatter
In the illustration below which of the following can you measure by the rotor - ANSlateral run out
ABS speed sensors rings - ANSshould not be hammered or tapered on
The key input for the abs control module comes from the - ANSwheel speed sensors
A cranked torn vacuum damper in a brake power booster would most likely cause - ANSa hard
pedal requiring very hard pedal effort
You have turned a rotor to remove score on the rotor. the thickness is now 1.155 what should
you do - ANSUse the rotor and install new brakes
Why don't disc brake systems usually need ADJ - ANSfriction between the caliper seal and
caliper position will keep the pads againist the rotor
In the above drawing you would find break fluid entering at points - ANS2 and 3
a common cause of pedal pulsation during brake application is - ANSimproperly torqued wheels
the tool shown below is used to - ANSADJ the brake shoes to drum size
which of the following incorrect service procedures will cause the brake to lock up - ANSmaster
cylinder push rod ADJ too long
Which of the fol;owing describes the correct sequence for bleeding brake lines on most split
diagonal - ANSread the manufacturers recommendation, the procedure varies depending on the
model
Which of the following is true about bleeding brake lines on most ABS equipment vechocles -
ANSmost ABS brake lines can be bled like conventional
Upon inspecting brake fluid condition tech observes a diagram master cylinder cup swollen -
ANSpetroleum produces appealed to the system
In disc brake assy the square cut seal is located - ANSIn caliper piston bore
You are installing a set of brake shoe linings that are not the same length - ANSsmaller to the
front of the car
Turning the brake drums - ANSuse damping strap to reduce chatter
In the illustration below which of the following can you measure by the rotor - ANSlateral run out
ABS speed sensors rings - ANSshould not be hammered or tapered on
The key input for the abs control module comes from the - ANSwheel speed sensors
A cranked torn vacuum damper in a brake power booster would most likely cause - ANSa hard
pedal requiring very hard pedal effort
You have turned a rotor to remove score on the rotor. the thickness is now 1.155 what should
you do - ANSUse the rotor and install new brakes
Why don't disc brake systems usually need ADJ - ANSfriction between the caliper seal and
caliper position will keep the pads againist the rotor
In the above drawing you would find break fluid entering at points - ANS2 and 3
a common cause of pedal pulsation during brake application is - ANSimproperly torqued wheels
the tool shown below is used to - ANSADJ the brake shoes to drum size
which of the following incorrect service procedures will cause the brake to lock up - ANSmaster
cylinder push rod ADJ too long
Which of the fol;owing describes the correct sequence for bleeding brake lines on most split
diagonal - ANSread the manufacturers recommendation, the procedure varies depending on the
model
Which of the following is true about bleeding brake lines on most ABS equipment vechocles -
ANSmost ABS brake lines can be bled like conventional
Upon inspecting brake fluid condition tech observes a diagram master cylinder cup swollen -
ANSpetroleum produces appealed to the system
In disc brake assy the square cut seal is located - ANSIn caliper piston bore
You are installing a set of brake shoe linings that are not the same length - ANSsmaller to the
front of the car
