Massachusetts 1B Hoisting License Exam Prep Questions And Answers Latest Updated 2024/2025 | Scored A+

Massachusetts 1B Hoisting License Exam Prep Questions And Answers Latest Updated 2024/2025 | Scored A+. manufacturer's specification: all hoisting machinery shall be operated in accor- dance with the: 2.  inoperable and secure: maintenance repair and refueling shall be done when the machine is: 3.  daily: visual inspection shall be made of wire ropes, bearings, gears, friction clutches, brakes, chain drives and other parts subject to wear on all hoisting machinery to ensure against development of unsafe conditions 4.  2: factory of safety. all parts of the crane and supports shall be designed, main- tained, and constructed to withstand all stresses resulting from intended use with a safety factor of not less than: 5.  exceed: wind speed must not manufacturer's recommendations for continued work operations. 6.  chocked or blocked: when the pile driver is not in use, the hammer shall be in the leads or lowered to the ground Massachusetts 1B Hoisting License Exam Prep Questions And Answers Updated 2024/2025 | Scored A+ 2 / 15 7. determine load weight before attempting any lift: the single most important precaution in rigging and hoisting is to: 8. defective components, failure to destroy defective components, using unsafe equipment, hazardous wind conditions, hazardous weather conditions, electrical contact, hoist line not plumb: common hoisting and rigging hazards include: 9. use a shackle: whenever 2 or more rigging ropes or straps are to be placed over a hook 10. A) rig loads to prevent any parts from shifting or dislodging during the lift B) keep the load under control at all times with taglines C) never wrap the hoist rope around the load D) the load line should be brought over the load's center of gravity before the lift is started E) make sure that everyone stands clear when loads are being lifted, lowered, and freed of slings **CORRECT ANSWER** F) all the above: when rigging, lifting and landing loads: 11. Mass. Dept. of Public Safety within one hour: in the event of death occurring in which hoist equipment is involved, who must be notified 3 / 15 12. more than 500lbs.; higher than 10 feet; bucket can handle more thand 1/4 yard of materials: according to chapter 146 what type of equipment requires a license to operate 13. wheel or track excavating equipment including all 2B & 2C equipment: whattype of equipment can your run with a 2A License 4 / 15 14. a valid drivers license, DOT medical card, and appropriate hoisting license.: what must you be in possession of when your are operating a crane in Massachusetts 15. Daily, Monthly (documented), and annually (Third Party): how often does the operator inspect his equipment? 16. Four: at a minimum, how many positions must be on every load chart 17. Never saddle a dead hours, clips aligned, proper spacing, proper torque. NOTE: even following the above, wire rope clips are not approved for overheadlifting. NOTE** this question uses a picture of 3 views: how do you make up an end connection with wire rope clips? 18. osha criteria, grade 8 or 80 or higher can be used for overhead lifting: chainslings are allowed as long as they comply with what 19. chapter 146, 520 CMR 6.0: what section of Massachusetts General Law do you work under 20. Forklift/Extending Boom without Cables: Class 1C covers what type of equipment 21. Completed application form, 1"x1.25" photo or color copy of your driver's license, copy of valid motor vehicle license or CDL license, DOT certificate documentation that you meet the criteria for a DOT medical examination or 5 / 15 1998 ANSI B30.5 qualifications for operators, or similar medical documentation, $75 fee (non-refundable): What must be submitted with the license renewal form 22. any license covered under 520 CMR 6.0 may be revoked or suspended for the following reasons: 1. false or misleading information on application for examination or license renewal 2. operating hoisting machinery under the influence of alcohol or drugs 3. failure to pay excise tax or other taxes 4. prior violations of licensing law 5. failure to report accidents as required by the department of public safety 6. failure to report a fatality as required by the department of public saftey 7. operating in an unsafe manner 8. failure to comply with any provision of this regulation: Why can your license be revoked or suspended? 23. revocation and/or renewal: when is re-examination required 24. lower all components to the ground: what do you do if the power fails during any hoisting operation