ABYC Advanced Pretest Correct 100%(RATED A+)

A metallic shore power inlet becomes hot to the touch. Which would not be a contributing factor? - ANSWER Temperature rating of shore-cord insulation An inter-circuit short can cause: - ANSWER " All of the above; Unrelated circuits to operate simultaneously; Components to work at reduced capacity; An over-current situation" Which of the following is addressed by ABYC A-32? - ANSWER Power conditioning and conversion LED navigation lights are required to meet: - ANSWER 72 Colregs Which of the following are recommended for 3-phase shore power? - ANSWER Power conditioning and phase-rotation monitoring Which of the following is an example of a power-quality issue? - ANSWER Nuisance tripping of magnetic circuit breakers What tool can be used instead of a power-quality analyzer to measure phase amplitude? - ANSWER DVOM All of the following are functions of a generator voltage regulator EXCEPT: - ANSWER Control generator power factor A true-DC wind generator might be inadvertently powered by the batteries if a ________ is not part of the installation. - ANSWER Blocking diode Which power sources can be seamlessly transferred? - ANSWER " All of the above; AC generators; Shore power; Inverters" Which of the following needs to be considered when retrofitting an electric-propulsion engine? - ANSWER Proper ventilation of batteries In a NMEA 2000 digital switching system it is necessary to use - ANSWER Terminating resistors A boat's hull potential is measured: - ANSWER Between a reference cell and main engine negative Which statement is correct pertaining to a NMEA 2000 system? - ANSWER " Both a and b; Resistors are to be used only at both ends of the system; NMEA cables provide power and data in a single cable" Slower than normal engine cranking could be an indication of all the following except: - ANSWER Battery fully charged