MICHIGAN STATE BRAKES CERTIFICATION EXAM NEW LATEST UPDATED
VERSION 2024-2025 COMPLETE EXAM 90 QUESTIONS AND CORRECT
DETAILED ANSWERS (100% CORRECT AND VERIFIED ANSWERS) |ALREADY
GRADED A+
Most 1995 & newer vehicles use which of the following types of wheels bearings on
non-drive wheel? - CORRECT ANSWER✔✔Sealed non-serviceable
to test a vacuum power brake booster in the vehicle, you should pump the brake
pedal at least 4 times, hold the brake pedal depressed, and start the engine. the
brake pedal should: - CORRECT ANSWER✔✔drop slightly and remain firm
You are installing a set of brake shoe linings that are not the same length.
Traditionally, the primary shoe lining is: - CORRECT ANSWER✔✔Smaller and
goes towards the front of the car.
A cracked or torn vacuum diaphragm in a brake power booster would most likely
cause: - CORRECT ANSWER✔✔a hard pedal feel requiring very high pedal effort
to stop
A mechanic finds gear lube inside both rear brake drums on a rear wheel drive
vehicle. What is the most likely cause of this problem? - CORRECT ANSWER✔✔A
plugged axle
Which of the following incorrect service procedures will cause brake lock-up? -
CORRECT ANSWER✔✔master cylinder push rod adjusted too long
, Which of the following describes the proper way to depressurized an ABS system?
- CORRECT ANSWER✔✔Pump the brake pedal at least 25 times (or more,
depending on the manufacturer's recommendation) with the ignition off.
The rear brakes are dragging after having new linings installed and the drums
machined. the most likely cause is the: - CORRECT ANSWER✔✔technician use
the parking brake to adjust shoes and the cable is stuck
When turning brake drums: - CORRECT ANSWER✔✔use a dampening strap to
reduce chatter
Which of the following is NOT a necessary drum brake measurement? - CORRECT
ANSWER✔✔run-out
On a 3-channel system, which wheels are on the same circuit? - CORRECT
ANSWER✔✔both rear wheels
One way to test an ABS wheel speed signal is to use _____ on your digital
multimeter. - CORRECT ANSWER✔✔AC volts
The key input for the ABS control module comes from the: - CORRECT ANSWER✔
✔wheel speed sensors
ABS speed sensor and sensor rings: - CORRECT ANSWER✔✔should not be
hammered or tapped on and should always be replaced as a matched set
Flexible brake hoses should be replaced: - CORRECT ANSWER✔✔when dampness
is evident on the hose
VERSION 2024-2025 COMPLETE EXAM 90 QUESTIONS AND CORRECT
DETAILED ANSWERS (100% CORRECT AND VERIFIED ANSWERS) |ALREADY
GRADED A+
Most 1995 & newer vehicles use which of the following types of wheels bearings on
non-drive wheel? - CORRECT ANSWER✔✔Sealed non-serviceable
to test a vacuum power brake booster in the vehicle, you should pump the brake
pedal at least 4 times, hold the brake pedal depressed, and start the engine. the
brake pedal should: - CORRECT ANSWER✔✔drop slightly and remain firm
You are installing a set of brake shoe linings that are not the same length.
Traditionally, the primary shoe lining is: - CORRECT ANSWER✔✔Smaller and
goes towards the front of the car.
A cracked or torn vacuum diaphragm in a brake power booster would most likely
cause: - CORRECT ANSWER✔✔a hard pedal feel requiring very high pedal effort
to stop
A mechanic finds gear lube inside both rear brake drums on a rear wheel drive
vehicle. What is the most likely cause of this problem? - CORRECT ANSWER✔✔A
plugged axle
Which of the following incorrect service procedures will cause brake lock-up? -
CORRECT ANSWER✔✔master cylinder push rod adjusted too long
, Which of the following describes the proper way to depressurized an ABS system?
- CORRECT ANSWER✔✔Pump the brake pedal at least 25 times (or more,
depending on the manufacturer's recommendation) with the ignition off.
The rear brakes are dragging after having new linings installed and the drums
machined. the most likely cause is the: - CORRECT ANSWER✔✔technician use
the parking brake to adjust shoes and the cable is stuck
When turning brake drums: - CORRECT ANSWER✔✔use a dampening strap to
reduce chatter
Which of the following is NOT a necessary drum brake measurement? - CORRECT
ANSWER✔✔run-out
On a 3-channel system, which wheels are on the same circuit? - CORRECT
ANSWER✔✔both rear wheels
One way to test an ABS wheel speed signal is to use _____ on your digital
multimeter. - CORRECT ANSWER✔✔AC volts
The key input for the ABS control module comes from the: - CORRECT ANSWER✔
✔wheel speed sensors
ABS speed sensor and sensor rings: - CORRECT ANSWER✔✔should not be
hammered or tapped on and should always be replaced as a matched set
Flexible brake hoses should be replaced: - CORRECT ANSWER✔✔when dampness
is evident on the hose
