MSSC QUALITY POST TEST ANSWERS|WITH COMPLETE SOLUTIONS|ALREADY GRADED A|DOWNLOAD TO PASS

1. Inspection data requires for making effective manufacturing decisions: Accurate data. 2. A feature of all mistake-proofing systems is: Automated inspection. 3. A manufacturer has several options to handle nonconforming materials. The option to use a nonconforming material is acceptable: Only if it does not affect performance or cause a safety hazard. 4. A process SOP should include clearly stated procedures for dealing with nonconforming materials. If nonconformity is detected and there are no written procedures, it is the responsibility of the frontline worker to: C. Refer the problem to a supervisor or responsible department. 5. Third-party audits provide evidence that a quality program meets standards. A ...C. Acquire or maintain certification. 6. An auditor bases his/her audit report on data collected by: Directly observing the process. Interviewing workers and supervisors. Examining production records. 7. Inspections can be carried out for several purposes, including as a part of continuous improvement. To perform inspections, workers should know how to: Read production documents. Use inspection and analysis tools Read safety and environmental standards. 8. A possible source of inaccuracy in inspection data is: Human error. 9. Communication breakdowns can lead to inaccuracies and poor decisions. Detailed instructions for communicating results must be included in every: Inspection plan. 10. The inspection frequency for any given process depends on a number of factors. This frequency is specified in a (n): Sampling plan. 11. The main purpose of inspecting the final product is: Product acceptance. 12. Many products require, a record of a material's history. This record is known as the product's: Traceability. 13. In some cases, nonconforming goods are shipped to a customer if the customer waives the specification. When this happens, workers should: Be aware that the shipment is an exception. 14. Many inspections are performed by frontline workers. Quality management systems require that the company: Provide training of proper procedures for testing. Include training in health, safety, and environmental procedures. Keep complete documentation of all training. 15. The purpose of a quality audit is to: Provide assurance that the process follows the guidelines of the quality plan. 16. The three types of quality audits are: Internal, external, and third-party. 17. An audit report is always presented to the person or organization requesting the audit. A summary of each discrepancy from standards should also be available to: Production workers involved in the process. 18. What documentation is required for "first piece" inspections? D. In-process form 19. Product testing must include shipping tests to: B. Identify problem areas in product design or assembly 20. If two angles are complementary, then both are angles. Acute 21. Which of the following is involved with reducing setup? First good piece every time 22. When using a nut, bolt, flat washer, and lock washer, the lock washer should be positioned: Between the nut and flat washer 23.Which of the following is included in a manufacturing process? Machine resources 24. Dial indicators are adaptable for use with: Snap gauges 25. Arrowheads are used on a drawing in many applications. One of the applications is lines. Cutting plane 26. Follow-up and closeout of audit-initiated corrective actions is a part of: The audit function 27. Which of the below organizations is primarily involved in helping companies to consistently produce high quality products? ISO 28. Upon review of production results, it was determined that 350 out of 5,000 pieces were "out of spec". What percentage of the production was "out of spec"? 7 percent