Actual 2024 AQA A-LEVEL DESIGN AND TECHNOLOGY: PRODUCT DESIGN 7552/2 Paper 2 Designing and Making Principles Merged Question Paper + Mark Scheme

AQA
A-level
DESIGN AND TECHNOLOGY:

PRODUCT DESIGN

7552/2
Paper 2 Designing and Making Principles

Question Paper + Mark scheme [MERGED]

June 2022

, Please write clearly in block capitals.


Centre number Candidate number


Surname ________________________________________________________________________

Forename(s) ________________________________________________________________________

Candidate signature ________________________________________________________________________
I declare this is my own work.



A-level
DESIGN AND TECHNOLOGY:
PRODUCT DESIGN
Paper 2 Designing and Making Principles


Time allowed: 1 hour 30 minutes
Materials For Examiner’s Use
For this paper you must have:
 normal writing and drawing instruments Question Mark
 a scientific calculator. 1
2–3
Instructions
 Use black ink or black ball-point pen. Use pencil only for drawing. 4
 Fill in the boxes at the top of this page. 5
 Answer all questions. 6
 You must answer the questions in the spaces provided. Do not write outside
the box around each page or on blank pages. 7
 If you need extra space for your answer(s), use the lined pages at the end of 8
this book. Write the question number against your answer(s). 9–10
 Do all rough work in this book. Cross through any work you do not want
11
to be marked.
12
Information 13
 The marks for questions are shown in brackets. 14
 The maximum mark for this paper is 80.
15
 There are 30 marks for Section A and 50 marks for Section B.
16
17
TOTAL




(JUN227552201)
G/KL/Jun22/E5 7552/2

, 2
Do not write
outside the
box
Section A – Product Analysis

Answer all questions in this section.



0 1 Figures 1 and 2 show two screwdrivers.

Figure 1 Figure 2

Jeweller’s screwdriver General purpose screwdriver




Figure 1 Figure 2

Handle material(s) Aluminium Thermoplastic and elastomer

Handle formed by Casting Injection moulding

Screwdriver tip Fixed tip Interchangeable magnetic attachment


Compare the two screwdrivers shown.

In your answer you should refer to:
ergonomics

material suitability
product function.
[12 marks]




(02)
G/Jun22/7552/2

, 3
Do not write
outside the
box

___________________________________________________________________________________

___________________________________________________________________________________

___________________________________________________________________________________

___________________________________________________________________________________

___________________________________________________________________________________

___________________________________________________________________________________

___________________________________________________________________________________

___________________________________________________________________________________

___________________________________________________________________________________

___________________________________________________________________________________

___________________________________________________________________________________

___________________________________________________________________________________

___________________________________________________________________________________

___________________________________________________________________________________

___________________________________________________________________________________

___________________________________________________________________________________

___________________________________________________________________________________

___________________________________________________________________________________

___________________________________________________________________________________

___________________________________________________________________________________

___________________________________________________________________________________

___________________________________________________________________________________

___________________________________________________________________________________
____
___________________________________________________________________________________ 12




Turn over 8


(03)
G/Jun22/7552/2