Questions & Answers Test QUESTIONS
AND VERIFIED SOLUTIONS 2026 EL
1. A vessel underway in a narrow channel observes a downbound vessel displaying a
flashing yellow light. According to the Inland Navigation Rules, what is the primary
purpose of this light signal?
A. To indicate a vessel engaged in fishing with trawls.
B. To signal a vessel constrained by its draft in a narrow channel.
C. To identify a vessel operating in a special anchorage area.
D. To warn of a vessel approaching a bend or crossing a fairway.
Answer: D. To warn of a vessel approaching a bend or crossing a fairway.
Rationale: In Inland Rules, a flashing yellow light indicates a vessel approaching a bend or
crossing a fairway where other vessels may be obscured. Option A is incorrect as fishing
vessels display red over white lights. Option B is incorrect as constrained-by-draft vessels
show three all-round red lights. Option C is incorrect as special anchorage areas are
marked by yellow buoys, not vessel lights.
2. While on a vessel with a twin-engine inboard setup, the port engine suddenly loses
power and emits black smoke. Which of the following is the most likely cause, and
what immediate action should be taken?
A. Fuel starvation due to a clogged filter; switch to the secondary filter and bleed the
system.
B. Overheating due to a failed impeller; reduce speed and monitor temperature.
C. Turbocharger failure; shut down the engine immediately and investigate.
D. Propeller entanglement; shift to neutral and inspect the shaft.
Answer: A. Fuel starvation due to a clogged filter; switch to the secondary filter and
bleed the system.
Rationale: Black smoke typically indicates incomplete combustion from fuel starvation or
over-fueling; a clogged filter is a common cause. Switching to a secondary filter and
bleeding the system is the correct immediate response. Option B would produce white
smoke (steam) and high temperature alarms. Option C would often result in blue smoke
and loss of power but not necessarily black smoke. Option D would cause vibration and
Page 1 of 81
,sudden RPM drop without smoke.
Page 2 of 81
,3. A vessel is navigating in fog with radar operating. The radar displays a target with
a relative motion line (RML) that is parallel to the heading line and pointing toward
the center. What does this indicate about the risk of collision?
A. The target is on a constant bearing and decreasing range, indicating a risk of collision.
B. The target is moving away and will pass astern.
C. The target is stationary and the vessel will pass clear.
D. The target is on a constant bearing and increasing range, indicating no risk.
Answer: A. The target is on a constant bearing and decreasing range, indicating a risk
of collision.
Rationale: A relative motion line parallel to the heading line and pointing toward the
center indicates a constant bearing with decreasing range, which is a classic sign of
collision risk. Option B would show the RML pointing away from center. Option C would
show the target stationary relative to the water, but with own vessel moving, the RML would
still point toward center if on collision course. Option D is incorrect because increasing
range would show RML pointing away from center.
4. A sailing vessel is on a starboard tack with the wind coming over its starboard side.
It is approaching a power-driven vessel from its port side. Which vessel is the stand-on
vessel?
A. The sailing vessel, because it is on starboard tack.
B. The power-driven vessel, because it is the give-way vessel.
C. The sailing vessel, because it is the less maneuverable vessel.
D. The power-driven vessel, because it is to the right.
Answer: B. The power-driven vessel, because it is the give-way vessel.
Rationale: Under COLREGs Rule 18, a power-driven vessel shall keep out of the way of a
sailing vessel. However, Rule 12 (sailing vessels) does not apply here because one vessel is
power-driven. The power-driven vessel is the give-way vessel and must take early and
substantial action to keep clear. Option A is incorrect because starboard tack rules apply
only between sailing vessels. Option C is incorrect because sailing vessels are not
automatically stand-on; they must still follow right-of-way rules. Option D is incorrect
because there is no 'right' rule; it's about give-way and stand-on.
Page 3 of 81
, 5. During a coastal passage, the GPS fails. The navigator must rely on deduced
reckoning (DR) using the vessel's speed log and compass. If the vessel has been
steering 045° true at 8 knots for 3 hours, but a current is setting 180° at 1.5 knots,
what is the vessel's actual course made good (CMG) and speed made good (SMG)?
A. CMG 045°, SMG 9.5 knots
B. CMG 045°, SMG 6.5 knots
C. CMG 052°, SMG 7.2 knots
D. CMG 038°, SMG 7.2 knots
Answer: C. CMG 052°, SMG 7.2 knots
Rationale: The current sets exactly opposite to the vessel's heading, reducing speed but not
changing course. However, the current is 180° (south) while the vessel is heading 045°
(northeast). The current vector is not directly opposing; it has a southerly component and a
westerly component. The resultant course made good will be slightly to the right of 045°
(toward east) because the current pushes south, but since the vessel is moving northeast,
the south current will push it slightly clockwise. Using vector addition: own ship vector: 8
knots at 045°. Current vector: 1.5 knots at 180°. Resultant: break into components: own
ship: x=8*sin45=5.66, y=8*cos45=5.66. Current: x=1.5*sin180=0, y=1.5*cos180=-1.5.
Sum: x=5.66, y=4.16. Resultant speed =
sqrt(5.66^2+4.16^2)=sqrt(32.04+17.31)=sqrt(49.35)=7.02 knots. Course =
atan2(5.66,4.16)=53.7°. So CMG ~054°, SMG ~7.0 knots. Option C (052°, 7.2) is closest.
Option A is incorrect because current reduces speed. Option B is incorrect because current
is not directly opposing. Option D is incorrect because current pushes course to the right,
not left.
Page 4 of 81