Ladwp Utility Services Specialist
Examination Questions And Correct
Answers (Verified Answers) Plus Rationales
2026 Q&A | Instant Download Pdf
SECTION 1: RATES, BILLING ANALYSIS & CUSTOMER RATE APPLICATION
1. A residential customer in Zone 1 uses 950 kWh in a billing period with a
baseline allocation of 500 kWh under Rate Schedule R-1A. How should a
Utility Services Specialist correctly explain the High Usage surcharge
application?
A. High Usage applies to all usage above 350 kWh regardless of baseline
B. High Usage applies only to customers on TOU rates
C. High Usage applies to usage exceeding 3 times the baseline allocation, so 950
kWh triggers review because Tier 2 is exceeded but High Usage would apply
above 1500 kWh in this case
D. High Usage is a flat $20 fee applied to any customer over 1000 kWh
Rationale: Under LADWP R-1A, baseline is climate-zone specific and High Usage
is triggered at 3x baseline, not a fixed 1000 kWh. For 500 kWh baseline, High
Usage starts at 1501 kWh. The Specialist must calculate Tier 1 (baseline), Tier 2
(up to 3x baseline), and High Usage. This tests ability to apply rate options to
billing history and explain potential savings, which is Task 4 and 28.
2. A small commercial customer on A-1-A rate complains of high summer bills.
Billing history shows demand never exceeds 25 kW but energy is 8,500
kWh/month. What is the most cost-effective rate recommendation to
analyze?
,A. Move to A-2-A primary voltage immediately
B. Keep A-1-A because demand is low
C. Analyze A-2-B Time-of-Use option with load shift potential and compare ECA
and RCA adjustments
D. Recommend R-1B residential TOU rate
Rationale: A-1-A is small general service non-demand. When energy is high but
demand stays below 30 kW, the next analysis must be A-2-A or A-2-B TOU to
leverage off-peak rates. The Specialist must extract usage history and build
comparative charts per Task 5. A-2-A primary requires customer-owned
transformer, not applicable, and R-1B is residential only.
3. When performing a rate analysis, which component is NOT part of LADWP's
total electric bill calculation?
A. Energy Charge based on kWh
B. Energy Cost Adjustment (ECA)
C. California Independent System Operator (CAISO) direct pass-through fee
billed separately
D. Reliability Cost Adjustment (RCA)
Rationale: LADWP is a vertically integrated municipal utility and bills ECA, RCA,
and base energy charges. CAISO charges are internalized, not separately line-
itemed to retail customers like in IOU territory. This tests Task 4 rate application
knowledge.
4. A customer with rooftop solar under Net Energy Metering (NEM) asks why
they still have a bill. What is the correct explanation?
A. NEM customers pay no LADWP charges
B. NEM customers still pay basic service charges, demand charges if applicable,
and non-bypassable charges, and excess generation is credited at avoided cost
per LADWP NEM rules
C. Solar credits eliminate ECA and RCA entirely
D. LADWP does not allow NEM for residential customers
,Rationale: LADWP NEM does not zero out the bill. The Customer Service Charge,
minimum bill, and adjustments still apply. Credits are at LADWP's defined rate,
not full retail after 2016 revisions. A USS must explain this per Task 1
communication duties.
5. For water billing, Tier 1 allocation is based on:
A. Flat 100 HCF for all single-family homes
B. Household size, lot size, season, and climate zone plus efficiency factors
C. Only lot size
D. Customer's previous year usage average
Rationale: LADWP water Tier 1 is customized using the Water Budget
methodology accounting for indoor needs (household size) and outdoor needs
(lot size, evapotranspiration, season). This is core to water conservation surveys
under Tasks 3 and 6.
6. A master-metered apartment building wants sub-metering rate analysis.
Which principle applies?
A. You must apply residential R-1A to the whole building
B. You must analyze whether the building qualifies for Multi-family A-1 or
Schedule Multi-family and explain that individual units cannot get separate
baseline allocations unless separately metered by LADWP
C. Each unit automatically gets full baseline
D. Commercial A rates never apply to apartments
Rationale: Master-metered properties cannot claim multiple baselines. The
Specialist must explain rate qualification and potential for conversion to
individual metering, a complex needs analysis per Task 2.
7. Which spreadsheet function would BEST determine the contribution of
each load type to total energy use from interval data?
A. VLOOKUP only
B. SUM only
C. SUMIFS combined with pivot tables to segment by end-use category and time
, period
D. CONCATENATE
Rationale: Task 5 requires building charts to determine contribution of each load
type. SUMIFS and pivots allow segmentation by HVAC, lighting, etc., from meter
data, which is exam-standard data analysis.
8. A customer is on TOU rate with peak 1pm-5pm. Their interval data shows
60% usage during peak. What recommendation has highest ROI?
A. Increase peak usage
B. Shift irrigation, EV charging, and laundry to off-peak and evaluate
programmable thermostat setback during peak
C. Install more inefficient equipment during peak to qualify for rebate
D. Change rate back without load shift analysis
Rationale: TOU ROI comes from load management. Task 6 and 14 emphasize
conservation techniques. Shifting controllable loads out of peak directly reduces
ECA/RCA peak impact and TOU energy charge.
9. Return on Investment (ROI) for energy efficiency should be calculated as:
A. (Initial Cost) / (Annual Savings)
B. (Annual Energy Cost Savings - Annual O&M Costs) / Initial Investment, with
simple payback and lifecycle considerations
C. Only first year savings
D. Rebate amount divided by total bill
Rationale: Per Task 8, ROI analysis must include O&M, expected life, and actual
savings, not just rebate. Simple payback is initial cost divided by annual savings,
but true ROI includes net benefits.
10.Energy Cost Adjustment (ECA) reflects:
A. Fixed profit margin for LADWP
B. Variable cost of fuel, purchased power, and related costs to supply electricity,
adjusted quarterly
Examination Questions And Correct
Answers (Verified Answers) Plus Rationales
2026 Q&A | Instant Download Pdf
SECTION 1: RATES, BILLING ANALYSIS & CUSTOMER RATE APPLICATION
1. A residential customer in Zone 1 uses 950 kWh in a billing period with a
baseline allocation of 500 kWh under Rate Schedule R-1A. How should a
Utility Services Specialist correctly explain the High Usage surcharge
application?
A. High Usage applies to all usage above 350 kWh regardless of baseline
B. High Usage applies only to customers on TOU rates
C. High Usage applies to usage exceeding 3 times the baseline allocation, so 950
kWh triggers review because Tier 2 is exceeded but High Usage would apply
above 1500 kWh in this case
D. High Usage is a flat $20 fee applied to any customer over 1000 kWh
Rationale: Under LADWP R-1A, baseline is climate-zone specific and High Usage
is triggered at 3x baseline, not a fixed 1000 kWh. For 500 kWh baseline, High
Usage starts at 1501 kWh. The Specialist must calculate Tier 1 (baseline), Tier 2
(up to 3x baseline), and High Usage. This tests ability to apply rate options to
billing history and explain potential savings, which is Task 4 and 28.
2. A small commercial customer on A-1-A rate complains of high summer bills.
Billing history shows demand never exceeds 25 kW but energy is 8,500
kWh/month. What is the most cost-effective rate recommendation to
analyze?
,A. Move to A-2-A primary voltage immediately
B. Keep A-1-A because demand is low
C. Analyze A-2-B Time-of-Use option with load shift potential and compare ECA
and RCA adjustments
D. Recommend R-1B residential TOU rate
Rationale: A-1-A is small general service non-demand. When energy is high but
demand stays below 30 kW, the next analysis must be A-2-A or A-2-B TOU to
leverage off-peak rates. The Specialist must extract usage history and build
comparative charts per Task 5. A-2-A primary requires customer-owned
transformer, not applicable, and R-1B is residential only.
3. When performing a rate analysis, which component is NOT part of LADWP's
total electric bill calculation?
A. Energy Charge based on kWh
B. Energy Cost Adjustment (ECA)
C. California Independent System Operator (CAISO) direct pass-through fee
billed separately
D. Reliability Cost Adjustment (RCA)
Rationale: LADWP is a vertically integrated municipal utility and bills ECA, RCA,
and base energy charges. CAISO charges are internalized, not separately line-
itemed to retail customers like in IOU territory. This tests Task 4 rate application
knowledge.
4. A customer with rooftop solar under Net Energy Metering (NEM) asks why
they still have a bill. What is the correct explanation?
A. NEM customers pay no LADWP charges
B. NEM customers still pay basic service charges, demand charges if applicable,
and non-bypassable charges, and excess generation is credited at avoided cost
per LADWP NEM rules
C. Solar credits eliminate ECA and RCA entirely
D. LADWP does not allow NEM for residential customers
,Rationale: LADWP NEM does not zero out the bill. The Customer Service Charge,
minimum bill, and adjustments still apply. Credits are at LADWP's defined rate,
not full retail after 2016 revisions. A USS must explain this per Task 1
communication duties.
5. For water billing, Tier 1 allocation is based on:
A. Flat 100 HCF for all single-family homes
B. Household size, lot size, season, and climate zone plus efficiency factors
C. Only lot size
D. Customer's previous year usage average
Rationale: LADWP water Tier 1 is customized using the Water Budget
methodology accounting for indoor needs (household size) and outdoor needs
(lot size, evapotranspiration, season). This is core to water conservation surveys
under Tasks 3 and 6.
6. A master-metered apartment building wants sub-metering rate analysis.
Which principle applies?
A. You must apply residential R-1A to the whole building
B. You must analyze whether the building qualifies for Multi-family A-1 or
Schedule Multi-family and explain that individual units cannot get separate
baseline allocations unless separately metered by LADWP
C. Each unit automatically gets full baseline
D. Commercial A rates never apply to apartments
Rationale: Master-metered properties cannot claim multiple baselines. The
Specialist must explain rate qualification and potential for conversion to
individual metering, a complex needs analysis per Task 2.
7. Which spreadsheet function would BEST determine the contribution of
each load type to total energy use from interval data?
A. VLOOKUP only
B. SUM only
C. SUMIFS combined with pivot tables to segment by end-use category and time
, period
D. CONCATENATE
Rationale: Task 5 requires building charts to determine contribution of each load
type. SUMIFS and pivots allow segmentation by HVAC, lighting, etc., from meter
data, which is exam-standard data analysis.
8. A customer is on TOU rate with peak 1pm-5pm. Their interval data shows
60% usage during peak. What recommendation has highest ROI?
A. Increase peak usage
B. Shift irrigation, EV charging, and laundry to off-peak and evaluate
programmable thermostat setback during peak
C. Install more inefficient equipment during peak to qualify for rebate
D. Change rate back without load shift analysis
Rationale: TOU ROI comes from load management. Task 6 and 14 emphasize
conservation techniques. Shifting controllable loads out of peak directly reduces
ECA/RCA peak impact and TOU energy charge.
9. Return on Investment (ROI) for energy efficiency should be calculated as:
A. (Initial Cost) / (Annual Savings)
B. (Annual Energy Cost Savings - Annual O&M Costs) / Initial Investment, with
simple payback and lifecycle considerations
C. Only first year savings
D. Rebate amount divided by total bill
Rationale: Per Task 8, ROI analysis must include O&M, expected life, and actual
savings, not just rebate. Simple payback is initial cost divided by annual savings,
but true ROI includes net benefits.
10.Energy Cost Adjustment (ECA) reflects:
A. Fixed profit margin for LADWP
B. Variable cost of fuel, purchased power, and related costs to supply electricity,
adjusted quarterly