DANTE LEVEL 2 TEST EXAM WITH
CORRECT ACTUAL QUESTIONS AND
CORRECTLY WELL DEFINED ANSWERS
LATEST 2025 -2026 ALREADY GRADED A+
A network that carries multiple, possibly unrelated data types (like internet,
VoIP, Dante, etc.) is:
- not possible
- an evolved network
- a converged network
- a dedicated network - ANSWERS-a converged network
Match the transmission method with its description. (Drag the descriptions at
right onto the appropriate method at left.)
- TCP
- UDP
,- A connection with delivery verification. Good for general internet traffic
where dropped packets are likely
- A one-way transmission with no delivery verification. Suitable for LANs
where traffic is under your control and interruptions are unlikely. Preferred
for real-time networks for lower overhead and lower latency - ANSWERS-TCP
--> A connection with delivery verification. Good for general internet traffic
where dropped packets are likely
UDP --> A one-way transmission with no delivery verification. Suitable for
LANs where traffic is under your control and interruptions are unlikely.
Preferred for real-time networks for lower overhead and lower latency
What happens if multiple devices have the Preferred Leader checkbox
marked?
- Both will become clock leaders - that will be reflected in Dante Controller.
Make sure only one device is selected as preferred leader to prevent this
problem
- Both will be elevated in the clock election process, only one of those two
will be come the clock leader
- The system will remain muted, since it is unable to determine which device
should be clock leader - ANSWERS-Both will be elevated in the clock election
process, only one of those two will be come the clock leader
,The redundant port allows for a second network connection in case the first
fails. Which of the following describes the connection and set-up of
redundant networks?
- Primary and secondary can be connected in the same broadcast domain
(VLAN). If one cable fails, the other will take over
- The secondary network is dormant until a problem is encoutered on the
primary. In that case, the primary network shuts down, and the secondary
network starts sending and receiving data
- The primary and secondary operate full time in separate broadcast domains.
If the connection fails on one network, it will continue to the other
- Dante devices establish redundancy by linking devices in a ring. If one like
breaks, the signal can traverse the ring in the other direction - ANSWERS-The
primary and secondary operate full time in separate broadcast domains. If
the connection fails on one network, it will continue to the other
When using redundant Dante networks, how do we configure the switches?
- The primary and secondary networks must remain in separate broadcast
domains (could be a VLAN) and each network must use separate subnets
- The primary and secondary networks must be linked together in a single
VLAN so a common clock is established - ANSWERS-The primary and
secondary networks must remain in separate broadcast domains (could be a
VLAN) and each network must use separate subnets
, What is the range of numbers for IP addresses in dotted-quad form? -
ANSWERS-0-255
What is the range of numbers we can actually use when assigning IP
addresses in dotted-quad form? - ANSWERS-1-254
Domain Name Service (DNS) - ANSWERS-Translates domain names into IP
addresses
If multiples are on a list, the first one to return an answer is followed
Subnets reserved for use on a local network - ANSWERS-192 . 168 . ___ . ___
10 . ___ . ___ . ___
172 . 16-31 . ___ . ___
169 . 254 . ___ . ___
What are the two primary DHCP settings? - ANSWERS-IP Range (a.k.a. DHCP
pool) and Lease Time (e.g. 24 hours)
What is the priority option for automatic IP addressing for Dante devices? -
ANSWERS-DHCP Server
If no DHCP server is found for automatic IP addressing, what is the back up
plan? - ANSWERS-Link Local
How does Link Local work? - ANSWERS-Assigns each device a random address
in 169 . 254 . ___ . ___
CORRECT ACTUAL QUESTIONS AND
CORRECTLY WELL DEFINED ANSWERS
LATEST 2025 -2026 ALREADY GRADED A+
A network that carries multiple, possibly unrelated data types (like internet,
VoIP, Dante, etc.) is:
- not possible
- an evolved network
- a converged network
- a dedicated network - ANSWERS-a converged network
Match the transmission method with its description. (Drag the descriptions at
right onto the appropriate method at left.)
- TCP
- UDP
,- A connection with delivery verification. Good for general internet traffic
where dropped packets are likely
- A one-way transmission with no delivery verification. Suitable for LANs
where traffic is under your control and interruptions are unlikely. Preferred
for real-time networks for lower overhead and lower latency - ANSWERS-TCP
--> A connection with delivery verification. Good for general internet traffic
where dropped packets are likely
UDP --> A one-way transmission with no delivery verification. Suitable for
LANs where traffic is under your control and interruptions are unlikely.
Preferred for real-time networks for lower overhead and lower latency
What happens if multiple devices have the Preferred Leader checkbox
marked?
- Both will become clock leaders - that will be reflected in Dante Controller.
Make sure only one device is selected as preferred leader to prevent this
problem
- Both will be elevated in the clock election process, only one of those two
will be come the clock leader
- The system will remain muted, since it is unable to determine which device
should be clock leader - ANSWERS-Both will be elevated in the clock election
process, only one of those two will be come the clock leader
,The redundant port allows for a second network connection in case the first
fails. Which of the following describes the connection and set-up of
redundant networks?
- Primary and secondary can be connected in the same broadcast domain
(VLAN). If one cable fails, the other will take over
- The secondary network is dormant until a problem is encoutered on the
primary. In that case, the primary network shuts down, and the secondary
network starts sending and receiving data
- The primary and secondary operate full time in separate broadcast domains.
If the connection fails on one network, it will continue to the other
- Dante devices establish redundancy by linking devices in a ring. If one like
breaks, the signal can traverse the ring in the other direction - ANSWERS-The
primary and secondary operate full time in separate broadcast domains. If
the connection fails on one network, it will continue to the other
When using redundant Dante networks, how do we configure the switches?
- The primary and secondary networks must remain in separate broadcast
domains (could be a VLAN) and each network must use separate subnets
- The primary and secondary networks must be linked together in a single
VLAN so a common clock is established - ANSWERS-The primary and
secondary networks must remain in separate broadcast domains (could be a
VLAN) and each network must use separate subnets
, What is the range of numbers for IP addresses in dotted-quad form? -
ANSWERS-0-255
What is the range of numbers we can actually use when assigning IP
addresses in dotted-quad form? - ANSWERS-1-254
Domain Name Service (DNS) - ANSWERS-Translates domain names into IP
addresses
If multiples are on a list, the first one to return an answer is followed
Subnets reserved for use on a local network - ANSWERS-192 . 168 . ___ . ___
10 . ___ . ___ . ___
172 . 16-31 . ___ . ___
169 . 254 . ___ . ___
What are the two primary DHCP settings? - ANSWERS-IP Range (a.k.a. DHCP
pool) and Lease Time (e.g. 24 hours)
What is the priority option for automatic IP addressing for Dante devices? -
ANSWERS-DHCP Server
If no DHCP server is found for automatic IP addressing, what is the back up
plan? - ANSWERS-Link Local
How does Link Local work? - ANSWERS-Assigns each device a random address
in 169 . 254 . ___ . ___
