FANUC ROBOTICS CERTIFICATION
EXAM QUESTIONS WITH 100%
VERIFIED ANSWERS
\Q\.When you turn the teach pendant on: - ANSWERS✔-It will permit motion control to the
operator using the teach pendant
\Q\.Things to do to avoid hard-stops and over travels? - ANSWERS✔-Set Axis Limits
\Q\.By Pressing SHIFT and the hard key COORD will show - ANSWERS✔-The "jog" menu
\Q\.The three ways of determining A user frame - ANSWERS✔-Direct method, Three point
method, Four point method
\Q\.In R-j3 series controller how many standards user frame? - ANSWERS✔-Nine (9)
\Q\.To define a remote tool center point (RTCP)? - ANSWERS✔-You use 3 point, 4 point and
direct entry
\Q\.What direction does the robot move in the WORLD Y+ if the robot is mounted on the floor?
- ANSWERS✔-To your left
\Q\.What are the two (2) ways to control the robots motion limits and boundaries? -
ANSWERS✔-Dual Check Safety & Axis Limits
EXAM QUESTIONS WITH 100%
VERIFIED ANSWERS
\Q\.When you turn the teach pendant on: - ANSWERS✔-It will permit motion control to the
operator using the teach pendant
\Q\.Things to do to avoid hard-stops and over travels? - ANSWERS✔-Set Axis Limits
\Q\.By Pressing SHIFT and the hard key COORD will show - ANSWERS✔-The "jog" menu
\Q\.The three ways of determining A user frame - ANSWERS✔-Direct method, Three point
method, Four point method
\Q\.In R-j3 series controller how many standards user frame? - ANSWERS✔-Nine (9)
\Q\.To define a remote tool center point (RTCP)? - ANSWERS✔-You use 3 point, 4 point and
direct entry
\Q\.What direction does the robot move in the WORLD Y+ if the robot is mounted on the floor?
- ANSWERS✔-To your left
\Q\.What are the two (2) ways to control the robots motion limits and boundaries? -
ANSWERS✔-Dual Check Safety & Axis Limits
