MSSC 4.0 Quality Practices & Measurements Questions and
Answers |Fall 2025/2026 Update | 100% Correct Latest
Question 1
A history of dependability and customer satisfaction should be considered when __________.
Correct Answer
Evaluating a potential supplier
Question 2
secondary auxiliary view
Correct Answer
An auxiliary view that is developed from a primary auxiliary view.
Question 3
What does the X-bar chart plot?
Correct Answer
The average value of each subgroup
Page 1 of 62
,Question 4
What two organizations set the standards for welding symbols?
Correct Answer
American National Standards Institute and American Welding Society
Question 5
X-bar and R charts
Correct Answer
A control chart which is a representation of process capability over time; displays the variability in the process average
and range across time.
Question 6
What is the basic measuring device on a dial caliper?
Correct Answer
Rule
Question 7
frequency chart
Correct Answer
A way to display how often an item, number, or range of numbers occurs.
Page 2 of 62
,Question 8
Joseph M. Juran, W. Edwards Deming, and C. Phillip Crosby contributed to the various approaches of __________.
Correct Answer
TQM, Total Quality Management
Question 9
ANSI
Correct Answer
American National Standards Institute
Question 10
Nonconformance
Correct Answer
when a material or garment does not meet the quality requirements defined in the specification
Question 11
PDCA cycle
Correct Answer
1. Plan
2. Do
3. Check
4. Act
Page 3 of 62
, Question 12
All employees in the plant benefit when
Correct Answer
Defect trend data is collected and problems are corrected
Question 13
defective
Correct Answer
not working properly
Question 14
What is the total caliper measurement equal to?
Correct Answer
Scale reading + dial reading
Question 15
Which method of tolerancing places the tolerances next to each dimension?
Correct Answer
Direct
Page 4 of 62
Answers |Fall 2025/2026 Update | 100% Correct Latest
Question 1
A history of dependability and customer satisfaction should be considered when __________.
Correct Answer
Evaluating a potential supplier
Question 2
secondary auxiliary view
Correct Answer
An auxiliary view that is developed from a primary auxiliary view.
Question 3
What does the X-bar chart plot?
Correct Answer
The average value of each subgroup
Page 1 of 62
,Question 4
What two organizations set the standards for welding symbols?
Correct Answer
American National Standards Institute and American Welding Society
Question 5
X-bar and R charts
Correct Answer
A control chart which is a representation of process capability over time; displays the variability in the process average
and range across time.
Question 6
What is the basic measuring device on a dial caliper?
Correct Answer
Rule
Question 7
frequency chart
Correct Answer
A way to display how often an item, number, or range of numbers occurs.
Page 2 of 62
,Question 8
Joseph M. Juran, W. Edwards Deming, and C. Phillip Crosby contributed to the various approaches of __________.
Correct Answer
TQM, Total Quality Management
Question 9
ANSI
Correct Answer
American National Standards Institute
Question 10
Nonconformance
Correct Answer
when a material or garment does not meet the quality requirements defined in the specification
Question 11
PDCA cycle
Correct Answer
1. Plan
2. Do
3. Check
4. Act
Page 3 of 62
, Question 12
All employees in the plant benefit when
Correct Answer
Defect trend data is collected and problems are corrected
Question 13
defective
Correct Answer
not working properly
Question 14
What is the total caliper measurement equal to?
Correct Answer
Scale reading + dial reading
Question 15
Which method of tolerancing places the tolerances next to each dimension?
Correct Answer
Direct
Page 4 of 62
