1|Page
MICHIGAN BUILDERS LICENSE EXAM NEWEST
2026/2027 COMPLETE ALL 230 QUESTIONS AND
100%CORRECT DETAILED ANSWERS (VERIFIED
ANSWERS) |ALREADY GRADED A+|BRAND NEW!!
The right amount of moisture and limitations with regard to
excessive heat or cold have an impact on which of these
in regards to concrete? - ANSWER-All of these
Flashing is so important in brick masonry because -
ANSWER-moisture is one of the biggest issues in
masonry
Joists should be__________ under each load bearing wall
that is parallel to the joists. - ANSWER-Doubled
,2|Page
The chief factor controlling the strength of concrete is
__________ - ANSWER-The water cement ratio
When pouring a monolithic slab, the minimum height for
the top of the slab should be how many inches above the
ground - ANSWER-6"
What is the first step i finishing a concrete slab? -
ANSWER-Screeding
The most basic type of concrete panel is the _______ -
ANSWER-Solid concrete panel
,3|Page
which of these should you NOT use to form slab edges for
a monolithic slab? - ANSWER-Precast concrete
When performing a slump test, the concrete should be
poured into the slump cone in three layers, each of which
is "rodded in" with _____ strokes of tamping rod -
ANSWER-25
A change order should include all of these except -
ANSWER-The engineers signature
An increase in volume of dirt after excavation is called -
ANSWER-Swell
, 4|Page
Which of these is NOT one of the three basic means of
demolishing a recently occupied house? - ANSWER-A two
step process of demolishing the house and then
deconstructing the most lucrative pieces
When trenching, the width below the top of the pipe should
be no more than _____ larger than the outer diameter of
the pipe. - ANSWER-1-2 ft
Ensuring that an excavation does not extend too far ahead
of the laid pipe minimizing all these EXCEPT - ANSWER-
the amount of work needed to be done
MICHIGAN BUILDERS LICENSE EXAM NEWEST
2026/2027 COMPLETE ALL 230 QUESTIONS AND
100%CORRECT DETAILED ANSWERS (VERIFIED
ANSWERS) |ALREADY GRADED A+|BRAND NEW!!
The right amount of moisture and limitations with regard to
excessive heat or cold have an impact on which of these
in regards to concrete? - ANSWER-All of these
Flashing is so important in brick masonry because -
ANSWER-moisture is one of the biggest issues in
masonry
Joists should be__________ under each load bearing wall
that is parallel to the joists. - ANSWER-Doubled
,2|Page
The chief factor controlling the strength of concrete is
__________ - ANSWER-The water cement ratio
When pouring a monolithic slab, the minimum height for
the top of the slab should be how many inches above the
ground - ANSWER-6"
What is the first step i finishing a concrete slab? -
ANSWER-Screeding
The most basic type of concrete panel is the _______ -
ANSWER-Solid concrete panel
,3|Page
which of these should you NOT use to form slab edges for
a monolithic slab? - ANSWER-Precast concrete
When performing a slump test, the concrete should be
poured into the slump cone in three layers, each of which
is "rodded in" with _____ strokes of tamping rod -
ANSWER-25
A change order should include all of these except -
ANSWER-The engineers signature
An increase in volume of dirt after excavation is called -
ANSWER-Swell
, 4|Page
Which of these is NOT one of the three basic means of
demolishing a recently occupied house? - ANSWER-A two
step process of demolishing the house and then
deconstructing the most lucrative pieces
When trenching, the width below the top of the pipe should
be no more than _____ larger than the outer diameter of
the pipe. - ANSWER-1-2 ft
Ensuring that an excavation does not extend too far ahead
of the laid pipe minimizing all these EXCEPT - ANSWER-
the amount of work needed to be done
