Terms in this set (36)
compressive strength
The amount of weight a block can
support
without collapsing is its _____.
hacked
Anout-of-plumb brick that tilts
toward themason's line is referred
to as_____.
toed
Anout-of-plumb unit that angles
away from the line is referred to as
_____.
The brick position that is used most stretcher
in laying walls is the_____.
3/8 inch wide
A buttered brick is placed and then
adjusted to achieve a mortar joint
that is approximately_____.
A closure unit is placed_____. in the middle of the course
less resistant to frost penetration
Compared to Grade N concrete
block, Grade
S concrete brick _____.
, bond beam
The cut that has the ends and inside
web of the block cut downone-
quarter andone-half of the way is
the_____ cut.
core
he openings in a CMU are referred
to as a_____.
1
The last course in a brick corner
lead will contain_____ brick(s).
six
The number of types that ASTM
classifes
concrete masonry units (block) into
is _____.
500 psi
onstructural concrete block has a
mini-mum compressive strength of
_____.
pattern bond
A purely decorative bond formed by
masonry
units and mortar joints on the face
of a surface
is called a _____.
compressive strength
The amount of weight a block can
support
without collapsing is its _____.
hacked
Anout-of-plumb brick that tilts
toward themason's line is referred
to as_____.
toed
Anout-of-plumb unit that angles
away from the line is referred to as
_____.
The brick position that is used most stretcher
in laying walls is the_____.
3/8 inch wide
A buttered brick is placed and then
adjusted to achieve a mortar joint
that is approximately_____.
A closure unit is placed_____. in the middle of the course
less resistant to frost penetration
Compared to Grade N concrete
block, Grade
S concrete brick _____.
, bond beam
The cut that has the ends and inside
web of the block cut downone-
quarter andone-half of the way is
the_____ cut.
core
he openings in a CMU are referred
to as a_____.
1
The last course in a brick corner
lead will contain_____ brick(s).
six
The number of types that ASTM
classifes
concrete masonry units (block) into
is _____.
500 psi
onstructural concrete block has a
mini-mum compressive strength of
_____.
pattern bond
A purely decorative bond formed by
masonry
units and mortar joints on the face
of a surface
is called a _____.
