JOURNEYMAN ELECTRICIAN PREP 2023/PRACTICE FULL SIZE EXAM 2
QUESTIONS AND ANSWERS LATEST DOWNLOADED 2025/2026 A
COMPLETE SOLUTION ALL ANSWERS GET IT 100% CORRECT BEST
RATED A+ FOR PASS
What is the minimum bending radius of a trade size 2-inch nonmetallic underground conduit
with conductors (NUCC)? - CORRECT ANSWERS
What is amperage rating for 4/0 THHW copper based on the 75℃ column - CORRECT
ANSWERS
Which type of flexible connection is permitted in Class I, Division 2 locations but not Class I,
Division 1 locations? - CORRECT ANSWERS
Which of the following statements about warning signs on stand-alone single 120-volt supply
systems is true? - CORRECT ANSWERS
Power-limited fire alarm conductors and cables meeting all other requirements may be
installed in non-concealed spaces if the exposed cable length does not exceed which length? -
CORRECT ANSWERS
Unless otherwise permitted, what is the minimum size conductor that may be used outside of
motors and controls on a crane? - CORRECT ANSWERS
What shall NOT be used to support other cables, raceways, or nonelectrical equipment? -
CORRECT ANSWERS
Legally required systems require a current supply that will be available within _____ after the
failure of the normal current supply. - CORRECT ANSWERS
What is overcurrent? - CORRECT ANSWERS
, JOURNEYMAN ELECTRICIAN PREP 2023/PRACTICE FULL SIZE EXAM 2
QUESTIONS AND ANSWERS LATEST DOWNLOADED 2025/2026 A
COMPLETE SOLUTION ALL ANSWERS GET IT 100% CORRECT BEST
RATED A+ FOR PASS
National Electrical Code metric units of measurement are provided in accordance with which
system standard? - CORRECT ANSWERS
What is the minimum size wire permitted as the grounding electrode conductor for
communications wires? - CORRECT ANSWERS
Current-carrying conductors used in low-voltage suspended ceiling power distribution systems
for load side utilization equipment shall be _____ and have a minimum wire size of _____. -
CORRECT ANSWERS
Manual reversing starters do not require which of the following? - CORRECT ANSWERS
The disconnecting means for a wind turbine at a one- or two-family dwelling must be located at
which of the following? - CORRECT ANSWERS
The specified vertical distance above the normal high-water level that has been determined
high enough to install electrical equipment in locations that may flood is called the -
CORRECT ANSWERS
The cord for an electrically operated in-sink waste disposal must fulfill which requirement? -
CORRECT ANSWERS
Which wiring method is permitted in a Class II, Division 2 location but not in a Class II, Division 1
location? - CORRECT ANSWERS
What is the maximum voltage in PV system dc circuits within a building larger than a two-family
dwelling? - CORRECT ANSWERS
QUESTIONS AND ANSWERS LATEST DOWNLOADED 2025/2026 A
COMPLETE SOLUTION ALL ANSWERS GET IT 100% CORRECT BEST
RATED A+ FOR PASS
What is the minimum bending radius of a trade size 2-inch nonmetallic underground conduit
with conductors (NUCC)? - CORRECT ANSWERS
What is amperage rating for 4/0 THHW copper based on the 75℃ column - CORRECT
ANSWERS
Which type of flexible connection is permitted in Class I, Division 2 locations but not Class I,
Division 1 locations? - CORRECT ANSWERS
Which of the following statements about warning signs on stand-alone single 120-volt supply
systems is true? - CORRECT ANSWERS
Power-limited fire alarm conductors and cables meeting all other requirements may be
installed in non-concealed spaces if the exposed cable length does not exceed which length? -
CORRECT ANSWERS
Unless otherwise permitted, what is the minimum size conductor that may be used outside of
motors and controls on a crane? - CORRECT ANSWERS
What shall NOT be used to support other cables, raceways, or nonelectrical equipment? -
CORRECT ANSWERS
Legally required systems require a current supply that will be available within _____ after the
failure of the normal current supply. - CORRECT ANSWERS
What is overcurrent? - CORRECT ANSWERS
, JOURNEYMAN ELECTRICIAN PREP 2023/PRACTICE FULL SIZE EXAM 2
QUESTIONS AND ANSWERS LATEST DOWNLOADED 2025/2026 A
COMPLETE SOLUTION ALL ANSWERS GET IT 100% CORRECT BEST
RATED A+ FOR PASS
National Electrical Code metric units of measurement are provided in accordance with which
system standard? - CORRECT ANSWERS
What is the minimum size wire permitted as the grounding electrode conductor for
communications wires? - CORRECT ANSWERS
Current-carrying conductors used in low-voltage suspended ceiling power distribution systems
for load side utilization equipment shall be _____ and have a minimum wire size of _____. -
CORRECT ANSWERS
Manual reversing starters do not require which of the following? - CORRECT ANSWERS
The disconnecting means for a wind turbine at a one- or two-family dwelling must be located at
which of the following? - CORRECT ANSWERS
The specified vertical distance above the normal high-water level that has been determined
high enough to install electrical equipment in locations that may flood is called the -
CORRECT ANSWERS
The cord for an electrically operated in-sink waste disposal must fulfill which requirement? -
CORRECT ANSWERS
Which wiring method is permitted in a Class II, Division 2 location but not in a Class II, Division 1
location? - CORRECT ANSWERS
What is the maximum voltage in PV system dc circuits within a building larger than a two-family
dwelling? - CORRECT ANSWERS
