Elevator Mechanic 2025/2026 Exam
Questions and Answers 100%
Guaranteed Success | Already Rated A+
ASME - 🧠ANSWER ✔✔American Society of Mechanical Engineers
DOSH - 🧠ANSWER ✔✔Division of Occupational Safety and Health
LADBS - 🧠ANSWER ✔✔Los Angeles Department of Building and Safety
Alteration made to conveyance shall comply with ASME A17.1-204 Section
- 🧠ANSWER ✔✔8.7
The seismic section of ASME A17.1-2004 and alterations made to
conveyances must also comply with this section - 🧠ANSWER ✔✔8.4
What must be submitted to the applicable Division Elevator office prior to
beginning construction or alterations on a conveyance
,Title 8 Sec 3000 - 🧠ANSWER ✔✔Letter of Intent
When shall Category One Tests on conveyances be completed
Title 8 Sec 3141.6 - 🧠ANSWER ✔✔Once every 12 months
What shall be provided on all conveyances regardless of the existence of
an emergency stop switch
ASME A17.1-2004
2.27.1.2 - 🧠ANSWER ✔✔Audible signaling device
When are Hoistway door unlocking devices on all conveyances required
Title 8 Sec 3141.7
ASME A17.1-2004
2.12.6 - 🧠ANSWER ✔✔Prohibited
What section should Group IV platform lifts and stairway chairlifts shall
comply with - 🧠ANSWER ✔✔ASME A18.1-2003
When setbacks or projections exceed this number of inches, occur in the
enclosure wall, the top of the setback or projection shall be beveled at an
angle not less than 75 degrees with the horizontal
,ASME A17.1-2004
2.1.6 - 🧠ANSWER ✔✔4 inches
At what height shall the hoistway enclosure of a Group IV elevator be
Unperforated
ASME A17.1-2004
2.1.1.2.2 - 🧠ANSWER ✔✔79 inches
For elevators installed after June 5, 1947, there shall be installed in the pit
of each elevator where the pit extends below the sill of the pit access door
a fixed vertical ladder. How many inches below the sill?
ASME A17.1-2004
2.2.4.2 - 🧠ANSWER ✔✔35 inches
On a Group IV elevator, what is the minimum pit lighting illumination that
should be provided at the pit floor
ASME A17.1-2004
2.2.5.1 - 🧠ANSWER ✔✔10 fc (foot candles)
For Group IV elevators that are not fully enclosed, how high of protection
should be provided on the hoistway sides that are located 59 inches or less
COPYRIGHT©JOSHCLAY 2025/2026. YEAR PUBLISHED 2025. COMPANY REGISTRATION NUMBER: 619652435. TERMS OF USE. PRIVACY
3
STATEMENT. ALL RIGHTS RESERVED
, from elevator equipment in areas accessible to other than elevator
personnel
ASME A17.1-2004
2.2.1.3 - 🧠ANSWER ✔✔94.5 inches
Permanent means shall be provided to prevent the accumulation of what?,
in the elevator pit
ASME A17.1-2004
2.2.2.3 - 🧠ANSWER ✔✔Water
In place of a sump pump, what else shall be provided on elevators
equipped with Firefighters' Emergency Operation
ASME A17.1-2004
2.2.2.5 - 🧠ANSWER ✔✔Drain
On a Group IV elevator, how far shall a pit ladder extend no less than how
many inches above the sill of the access door
ASME A17.1-2004
2.2.4.2 - 🧠ANSWER ✔✔48 inches
Questions and Answers 100%
Guaranteed Success | Already Rated A+
ASME - 🧠ANSWER ✔✔American Society of Mechanical Engineers
DOSH - 🧠ANSWER ✔✔Division of Occupational Safety and Health
LADBS - 🧠ANSWER ✔✔Los Angeles Department of Building and Safety
Alteration made to conveyance shall comply with ASME A17.1-204 Section
- 🧠ANSWER ✔✔8.7
The seismic section of ASME A17.1-2004 and alterations made to
conveyances must also comply with this section - 🧠ANSWER ✔✔8.4
What must be submitted to the applicable Division Elevator office prior to
beginning construction or alterations on a conveyance
,Title 8 Sec 3000 - 🧠ANSWER ✔✔Letter of Intent
When shall Category One Tests on conveyances be completed
Title 8 Sec 3141.6 - 🧠ANSWER ✔✔Once every 12 months
What shall be provided on all conveyances regardless of the existence of
an emergency stop switch
ASME A17.1-2004
2.27.1.2 - 🧠ANSWER ✔✔Audible signaling device
When are Hoistway door unlocking devices on all conveyances required
Title 8 Sec 3141.7
ASME A17.1-2004
2.12.6 - 🧠ANSWER ✔✔Prohibited
What section should Group IV platform lifts and stairway chairlifts shall
comply with - 🧠ANSWER ✔✔ASME A18.1-2003
When setbacks or projections exceed this number of inches, occur in the
enclosure wall, the top of the setback or projection shall be beveled at an
angle not less than 75 degrees with the horizontal
,ASME A17.1-2004
2.1.6 - 🧠ANSWER ✔✔4 inches
At what height shall the hoistway enclosure of a Group IV elevator be
Unperforated
ASME A17.1-2004
2.1.1.2.2 - 🧠ANSWER ✔✔79 inches
For elevators installed after June 5, 1947, there shall be installed in the pit
of each elevator where the pit extends below the sill of the pit access door
a fixed vertical ladder. How many inches below the sill?
ASME A17.1-2004
2.2.4.2 - 🧠ANSWER ✔✔35 inches
On a Group IV elevator, what is the minimum pit lighting illumination that
should be provided at the pit floor
ASME A17.1-2004
2.2.5.1 - 🧠ANSWER ✔✔10 fc (foot candles)
For Group IV elevators that are not fully enclosed, how high of protection
should be provided on the hoistway sides that are located 59 inches or less
COPYRIGHT©JOSHCLAY 2025/2026. YEAR PUBLISHED 2025. COMPANY REGISTRATION NUMBER: 619652435. TERMS OF USE. PRIVACY
3
STATEMENT. ALL RIGHTS RESERVED
, from elevator equipment in areas accessible to other than elevator
personnel
ASME A17.1-2004
2.2.1.3 - 🧠ANSWER ✔✔94.5 inches
Permanent means shall be provided to prevent the accumulation of what?,
in the elevator pit
ASME A17.1-2004
2.2.2.3 - 🧠ANSWER ✔✔Water
In place of a sump pump, what else shall be provided on elevators
equipped with Firefighters' Emergency Operation
ASME A17.1-2004
2.2.2.5 - 🧠ANSWER ✔✔Drain
On a Group IV elevator, how far shall a pit ladder extend no less than how
many inches above the sill of the access door
ASME A17.1-2004
2.2.4.2 - 🧠ANSWER ✔✔48 inches
