Icc S1C Structural Steel and Bolting Codes Study Guide

•According to the AISC Steel Construction Manual, Part 1, for a W16 x 57 beam,
which of the following dimensions would be considered within tolerance for the
flange width? 7-9/32

•According to the AISC specifications for structural steel buildings, a certified
mill test report in accordance with_ constitutes sufficient evidence of conformity
for rolled shapes manufactured in A36 steel. ASTM A6

•A MC12 shape with a web thickness of 7/16 in. will have a nominal weight
of_lb./ft. 35

•According to the specification for structural joints using ASTM A325 or A490
bolts, the thread length of a bolt with a nominal diameter of 1 in. is_in. 1-3/4

•A number “3” stamped on an ASTM A325 bolt means the bolt is: weathering steel

•Is a tension control A325 bolt required to be identified with markings? Yes,
Manufacturer’s identification mark

•The web thickness of a W30x191 steel member is_in. 11/16

•According to the specification for structural joints using high-strength bolts,
nuts and washers received with a light residual coating of oil shall be: Accepted

•According to the specification for structural joints using high-strength bolts,
hardened washers shall be used with A490 bolts if the material being bolted has a
specified yeld point less than_ksi? 40

•The web thickness of an S12 x 31.8 steel member is_in. 3/8