Study Guide for NYC HP Boiler License Final State Exam

Study Guide for NYC HP Boiler License Final State Exam 10% - CORRECT ANSWER-The minimum blowdown for a spring loaded safety valve shall be of what percent of the set pressure? With an Inspectors Guage - CORRECT ANSWER-How is the Main Steam pressure gages tested? The NYC Plumbing Code - CORRECT ANSWER-Who is in charge of the code for any plumbing installations? Annually - CORRECT ANSWER-When will anchorage or guides be inspected? 3 Brass Washout Plugs 1" in size - CORRECT ANSWER-How many brass washout plugs does a miniature boiler have? Weekly - CORRECT ANSWER-How often is Hp piping expansion joints inspected? 2 hours at no less than 100 PSIG - CORRECT ANSWER-How long should a Hydronic System be pressure tested for? Shut off Clock - CORRECT ANSWER-How is a guage protected from excessive pressure? Plumbing Inspector, Architect, Licensed PE, Master Plumber, or Agency by the D.O.B - CORRECT ANSWER-Who is authorized to witnessing a test on a gas piping system? Remote control for burner - CORRECT ANSWER-How should a remote disconnect be labeled? Over 200 Psig - CORRECT ANSWER-When is a fusible plug not needed to be installed on a boiler? Pressure tested annually - CORRECT ANSWER-When shall a power boiler with a MAWP over 400 be tested? Size, Location, Operating Pressure + Temperature of the Pressure vessel, and Type + Specification of the PRV - CORRECT ANSWER-What shall a Design plan of a boiler and application contains but not limited to? The Welding Agency and shall be available to the D.O.B - CORRECT ANSWER-Who is responsible for maintaining the copies of the certified welder qualifications report? The Installer - CORRECT ANSWER-Who needs to furnish