2023 AQA A-level DESIGN AND TECHNOLOGY: PRODUCT DESIGN 7552/2 Paper 2 Designing and Making Principles Question Paper & Mark scheme (Merged) June 2023 [VERIFIED]

2023 AQA A-level DESIGN AND TECHNOLOGY: PRODUCT DESIGN 7552/2 Paper 2 Designing and Making Principles Question Paper & Mark scheme (Merged) June 2023 [VERIFIED] Centre number Candidate number Surname ________________________________________________________________________ Forename(s) ________________________________________________________________________ Candidate signature ________________________________________________________________________ I declare this is my own work. A-level DESIGN AND TECHNOLOGY: PRODUCT DESIGN Paper 2 Designing and Making Principles Friday 16 June 2023 Morning Time allowed: 1 hour 30 minutes Materials For this paper you must have: normal writing and drawing instruments a scientific calculator. Instructions Use black ink or black ball-point pen. Use pencil only for drawing. Fill in the boxes at the top of this page. Answer all questions. You must answer the questions in the spaces provided. Do not write outside the box around each page or on blank pages. If you need extra space for your answer(s), use the lined pages at the end of this book. Write the question number against your answer(s). Do all rough work in this book. Cross through any work you do not want to be marked. Information The marks for questions are shown in brackets. The maximum mark for this paper is 80. There are 30 marks for Section A and 50 marks for Section B. For Examiner’s Use Question Mark 1 2 3 4 5 6 7–8 9–10 11–12 13–14 15 16 17 TOTAL 2 Section A – Product Analysis Answer all questions in this section. 0 1Figures 1 and 2 show two wheelbarrows. Figure 1 Figure 2 Figure 1 Figure 2 Wheel Rotationally moulded hollow Low carbon steel hub with spherical HDPE tyre rubber tyre Bucket Injection moulded HDPE Press formed powder coated low carbon steel Frame Powder coated low carbon steel Powder coated low carbon steel Compare the suitability of the two wheelbarr