BECC Mod 4 study set practice questions and answers

BECC Mod 4 study set practice questions and answers The Fireman System originates below the waterline with the __________. - CORRECT ANSWERS-Sea Chest Which valve is the last valve you open before putting the pump on line and the first valve you will shut when securing the pump? - CORRECT ANSWERS-Fire Pump Discharge Valve What valves are used to isolate system components? - CORRECT ANSWERS-Cutout, Discharge, and Cross Connect Valves Gate, Ball, Globe (Pump Discharge), or High Performance butterfly valves are considered ________________. - CORRECT ANSWERS-Cutout Valves For which monitoring method must the assigned watchstander notify DCC that the fire pump is aligned for operation? - CORRECT ANSWERS-Local Secondary, or alternate fireman monitoring is conducted from the Damage Control Deck, or under emergency conditions at the _________. - CORRECT ANSWERSPump Which methods are used to control fire pump or firemain valve operations? - CORRECT ANSWERS-Remote, Local, and Automatic Relief valves protect the fireman system from over-pressurization by relieving pressure at approximately _____ PSIG above the firemain design pressure. - CORRECT ANSWERS-50 Where is a coupling guard installed on the fire pump? - CORRECT ANSWERS-Over the rotating shaft Which pipe runs fore-to-aft of the ship and carries the firemain water? - CORRECT ANSWERS-Main The _________ firemain system uses a main that extends forward and aft on the damage control deck. - CORRECT ANSWERS-Single Which firemain system consists of two single fore-and-aft, cross connected mains? - CORRECT ANSWERS-Horizontal loop