PHM 250 Exam Questions with Correct Solutions
Tainted solutions and supplies due to nonsterile compounding procedures
Absence of guidelines to ensure uniform quality and quantity of LVP ingredients
Lack of sources to supply mass-produced , sterile, IV base solutions
Which of the following was a main reason why consistent, successfully treatment with LVP
solutions was not widely implemented prior to the 1920s?
intravenous
Sterile parenteral are most often administered by which route?
An LVP that administers continuous hydration and electrolytes
Which of the following statements most closely describes the term continuous infusion?
The facility's P&P manual, which reinforces the principles set forth in USP chapter <797>
Which of the following items provides guidelines for aseptic technique procedures that must be
followed during LVP preparation?
Wiping down supply items prior to entering the clean room
Within the sterile compounding environment, what is the primary use for aseptic, presaturated
cleaning wipes?
, None of the above
(within the DCA of the hood, within the outer six-inch zone of the hood, in front of the
prefilter)
Upon entering the clean room, where should IV technician place the transport vehicle?
With in the outer 6-inch zone of the hood
Where should small supply items such as needles and swabs be kept during sterile compounding
procedures?
Within the DCA of the hood
Where should a large item, such as an IV bag that has been removed from its dust cover, be kept
during sterile compound procedures?
The needle, syringe tip, Vial top, and injection port
Which of the following groups of supply components lists all of the critical sites that must not be
touched or shadowed during LVP preparation?
using your dominant hand, hold the syringe barrel like a dart, with the needle bevel
pointing up.
Which of the following describes the proper method of holding a syringe when inserting the
needle and syringe unit into a vial?
The needle and syringe tip
Which of the following critical sites should never be cleaned with an alcohol swab?
Tainted solutions and supplies due to nonsterile compounding procedures
Absence of guidelines to ensure uniform quality and quantity of LVP ingredients
Lack of sources to supply mass-produced , sterile, IV base solutions
Which of the following was a main reason why consistent, successfully treatment with LVP
solutions was not widely implemented prior to the 1920s?
intravenous
Sterile parenteral are most often administered by which route?
An LVP that administers continuous hydration and electrolytes
Which of the following statements most closely describes the term continuous infusion?
The facility's P&P manual, which reinforces the principles set forth in USP chapter <797>
Which of the following items provides guidelines for aseptic technique procedures that must be
followed during LVP preparation?
Wiping down supply items prior to entering the clean room
Within the sterile compounding environment, what is the primary use for aseptic, presaturated
cleaning wipes?
, None of the above
(within the DCA of the hood, within the outer six-inch zone of the hood, in front of the
prefilter)
Upon entering the clean room, where should IV technician place the transport vehicle?
With in the outer 6-inch zone of the hood
Where should small supply items such as needles and swabs be kept during sterile compounding
procedures?
Within the DCA of the hood
Where should a large item, such as an IV bag that has been removed from its dust cover, be kept
during sterile compound procedures?
The needle, syringe tip, Vial top, and injection port
Which of the following groups of supply components lists all of the critical sites that must not be
touched or shadowed during LVP preparation?
using your dominant hand, hold the syringe barrel like a dart, with the needle bevel
pointing up.
Which of the following describes the proper method of holding a syringe when inserting the
needle and syringe unit into a vial?
The needle and syringe tip
Which of the following critical sites should never be cleaned with an alcohol swab?
